Korg KROSS - SYSTM (System)

0: GLOBAL 0–2: SYSTM (System)
157
1, 2: This curve produces change when strong aftertouch pressure
is applied.
3 (Normal): The normal curve.
4, 5: This curve produces change even when light pressure is
applied.
6, 7: These curves produce change in 24 or 12 steps. Curve
number 7 allows change over twelve steps, so when using
aftertouch to modify the pitch, you can set the range of
modification to one octave, and use aftertouch to vary the pitch in
semitone steps.
8: This is a random curve. Use this when you wish to create
special effects, or to use aftertouch to apply unpredictable
modulation.
Octave SW On Value [-3,-2,-1,+1,+2,+3]
This specifies the octave value. This setting is effective when the
REALTIME CONTROLS section TONE 2 row's OCTAVE is
turned on. The default value is -1.
TIP: The OCTAVE dialog box appears when the REALTIME
CONTROLS section TONE 2 row's OCTAVE is turned on. While
this dialog box is shown, you can also use the cursor buttons , 
to set the octave value.
0–2: SYSTM (System)
Effect SW
IFX [Off, On]
On (checked): The FX ROUTING–IFX settings for each Effect
On/Off in Program, Combination, and Sequencer modes will be
valid.
Off (unchecked): All insert effects IFX1–5 will be off.
MFX [Off, On]
On (checked): The 1 (MFX1) and 2 (MFX2) Effect On/Off settings in the
SETUP tab of the MFX page in Program, Combination, and Sequencer
modes will be valid.
Off (unchecked): Master Effect1 and 2 (MFX1, 2) will be off.
These Effect On/Off settings are linked with the MASTER FX on/
off setting in the REALTIME CONTROLS section's EFFECT row.
These settings will always be turned on when you power-on
the KROSS.
When IFX or MFX settings are switched, control change
messages CC#92 (effect control 2), CC#94 (effect control 4),
and CC#95 (effect control 5) will be transmitted respectively.
The transmitted data will be 0 for off, and 127 for on.
ARP/SS (STEP SEQ)/DT (DRUM TRACK)
All Off [Off, On]
On (checked): All arpeggiator, Step Squencer and Drum Track
functions will be off. These functions will not run even if the ARP
button, RUN button, or DRUM TRACK button respectively are on.
Off (unchecked): The arpeggiator, step sequencer, and Drum Track
will function according to the settings of the applicable mode.
LOAD ARP WHEN CHANGING
Program [Off, On]
On (checked): When you switch programs, the arpeggiator
settings stored in that program will be used. Normally you will use
the On setting.
Off (unchecked): The arpeggiator settings will not change even if
you switch programs. Use this setting if you want to switch
Program sounds without changing the phrases from the
arpeggiator.
Combination [Off, On]
On (checked): When you switch combinations, the arpeggiator
settings stored in that combination will be used. Normally you will
use the On setting.
Off (unchecked): The arpeggiator settings will not change even if
you switch combinations. Use this setting if you want only to
switch combination sounds without changing the phrases from the
arpeggiator.
1
0
MAX
127
After Touch (MIDI In→TG)
3
4
5
7
2
6
8:RANDOM
Aftertouch
eect