Korg KROSS - Edit

Program mode
56
15–2: EDIT
This page appears when you hold down the EXIT button
( ) and press the front panel STEP SEQ ACTIVE button
().
The step on/off status of front panel pads 1–16 is linked with the
indication in this page.
STEP */* [1...64/01...64]
This shows the position and Length of the step that's selected in
this page.
ZONE [A, B, C, D]
The currently-shown zone is indicated by [ ].
This is linked with the lit status of the front panel A/B/C/D LEDs.
A/B/C/D indicate the following ranges of steps.
A: Steps 1-16
B: Steps 17-32
C: Steps 33-48
D: Steps 49-64
STATUS [STOP, RUN]
Indicates whether the step sequencer is stopped (STOP) or running
(RUN).
TONE 01 (Kick/Note No.) [Step Off, On]
TONE 02 (Snr 1/Note No.) [Step Off, On]
TONE 03 (Snr 2/Note No.) [Step Off, On]
TONE 04 (H.H X/Note No.) [Step Off, On]
TONE 05 (H.H O/Note No.) [Step Off, On]
TONE 06 (Crash/Note No.) [Step Off, On]
TONE 07 (Ride/Note No.) [Step Off, On]
TONE 08 (Tom L/Note No.) [Step Off, On]
TONE 09 (Tom H/Note No.) [Step Off, On]
TONE 10 (Perc 1/Note No.) [Step Off, On]
TONE 11 (Perc 2/Note No.) [Step Off, On]
TONE 12 (SFX/Note No.) [Step Off, On]
Turn the steps of each tone on/off. You can use the 1–16 pads or
the ENTER button to turn steps on/off. (see “Entering a pattern”
on page 89 of the Operation Guide)
If you want to change the sound (instrument) of each tone, adjust
settings in the P–STEP SEQ> INST page or use the Assign Inst to
Tone function. The note number is shown if you've selected ALL
for this setting, and the group name or abbreviation is shown if
you've selected GROUP.
You can also specify velocity and accent on/off for each step. Use
the Edit Step Parameters function to adjust this setting.
ACCENT [Off, On]
Specifies an accent for the step. (see “To add an accent to a step”
on page 90 of the Operation Guide)
Indicates the tone for which you can use the
front panel 1--16 pads to turn steps on/o.
When you turn RUN on, the indication will move
to the left, showing the currently-playing step.