2: C–TONE ADJ (Tone Adjust) 2–1: TONE ADJUST
75
2: C–TONE ADJ (Tone Adjust)
The Tone Adjust function lets you make simple changes to the
sound by adjusting the main program parameters for each timbre,
such as the filter or the filter and amp EG, giving you an easy way
to adjust the sound.
The results of editing the Tone Adjust parameters for each timbre
are saved in the combination.
This lets you adjust the sound of each timbre without modifying
the original program sounds. For example, it's easy to brighten the
sound of a timbre by raising its cutoff frequency so that it will fit
better with the other sounds of the combination.
Tone Adjust settings and MIDI control changes
Many of the program parameters that are affected by Tone Adjust
can also be modified via MIDI CC.
Adjustments via Tone Adjust and changes via MIDI CC are
always enabled; these two are combined to determine the actual
change that is applied.
The MIDI control change numbers (CC#) corresponding to each
Tone Adjust parameter are shown below.
Cutoff: CC#74
Resonance: CC#71
EG Intensity: CC#79
Vel. Intensity: Not supported
Attack: CC#75
Decay: CC#75
Sustain: CC#70
Release: CC#72
See page 311, 317
2–1: TONE ADJUST
The Tone Adjust function lets you make simple changes to the
sound by adjusting the timbre program's main parameters, such as
the filter or the filter and amp EG.
Most of these functions adjust (scale) the parameter settings of the
timbre programs. Unless otherwise noted, “scaling” means that the
parameters are at their programmed values when the controller is
at 64, at their minimum when the controller is at -99, and at their
maximum when the controller is at +99. For another look at this,
please see the diagram below.
CC parameter scaling
Timbre 01...16 (Timbre Number)
To select a timbre (active timbre), place the cursor at one of the
following parameters, and use the cursor buttons to switch
timbres.(see page 71)
Cutoff (Filter Cutoff) [–99...+99]
Adjusts the cutoff frequency of filters A and B.
Resonance (Filter Resonance) [–99...+99]
Adjusts the resonance of filters A and B.
EG Intensity (Filter EG Intensity) [–99...+99]
Adjusts the effect of the filter EG on the cutoff frequency of filters
A and B.
Vel. Intensity (Amp Velocity Intensity) [–99...+99]
Adjusts the velocity intensity for the amp level.
Timbre Info.
Shows the settings of timbres 1–16 for the parameter that you're
editing.
Soloed timbres are indicated by (S).
99
00
640 127
CC Value
Parameter
Value
As Programmed
To Next Page
Loading...
Need help?
General
