Korg KROSS - MIX (Track Mixer)

Sequencer mode
106
0–3: MIX (Track Mixer)
Here you can set the pan and volume of each MIDI track.
The pan and volume that you specify here will be used when you
play back or record from the beginning of the song. If you change
the settings during recording, the changes will be recorded as
MIDI data, and pan and volume will change during playback. You
can also change the settings during playback. However, when the
song reaches a location where pan or volume data was recorded,
the settings will change accordingly.
Track 01...16 (Track Number)
To select a track, place the cursor at one of the following
parameters, and use the cursor buttons   to switch tracks. (see
page 105)
Sound [Play, Mute]
This determines whether or not the Track will sound.
Play: The track will sound.
Mute: The track will not sound.
Pan [RND, L001...C064...R127]
Here you can set the pan for each MIDI track.
L001…C064…R127: A setting of L001 is far left and R127 is far
right. A setting of C064 will reproduce the oscillator pan setting of
the Program mode.
If a mono insert effect is in use, the settings you make here will be
ignored. In this case, the Pan: #8 parameter in S–FX ROUTING
>MIXER page will adjust the panning of the sound after the Insert
Effect. For more information, please see the “Mixer” section on
page 212..
Random: The pan position will change randomly at each note-on.
If Status (SEQ> PROG) is INT or BTH, CC#10 Pan can be
received to control the panning. When receiving CC#10, a
value of 0 or 1 is far left, 64 is center, and 127 is far right.
When you change the song or return to the beginning of the
song, tracks where the Status is EXT, EX2 or BTH will
transmit the pan you specify here as a MIDI message (except
for RND). (See G–MIDI> OUT SEQ Mode “Track MIDI
Out” on page 162)
Volume [000...127]
Here you can set the volume of each MIDI track.
When Status (SEQ> PROG) is INT or BTH, CC#7 Volume
can be received to control the volume. The volume of a track
is determined by multiplying the MIDI Volume (CC#7) and
Expression (CC#11) values. When you change the song or
return to the beginning of the song, tracks where Status is
EXT, EX2 or BTH will transmit the volume you specify here
as a MIDI Volume message. (See G–MIDI> OUT SEQ Mode
“Track MIDI Out” on page 162)
Track Info.
Shows the settings of tracks 1–16 for the parameter that you're
editing.
Note: If this is disabled because of the setting of another
parameter, “–” is shown.
OSC1:
Amp1 Pan=L001
OSC2:
Amp2 Pan=R127
Left
Center
Right
Pan (CC#10)
C064
Left
Center
Right
L032
L001
R096
R127
Left
Center
Right
Left
Center
Right
OSC1
OSC2
OSC1
OSC2
OSC1:
Amp1 Pan=L032
OSC2:
Amp2 Pan=R096
Pan (CC#10)
C064
L032
L001
R096
R127
OSC1:
Amp1 Pan=C064
OSC2:
Amp2 Pan=C064
Left
Center
Right
Pan (CC#10)
C064
Left
Center
Right
L032
L001
R096
R127
OSC1
OSC2