Korg KROSS - Delete Step; Insert Step

Global/Media mode
180
1. In “From Step”, select the range of steps that you wish to
copy.
2. In “To Step,” select the copy destination step.
If you selected more than one step in From Step, the steps will be
copied starting at To St ep and continuing through the steps to the
right.
Delete Step
This function deletes the step parameters (Tone, Pitch Offset,
Gate, Velocity, Flam) of the currently selected step number.
Subsequent steps will move one column toward the left.
Insert Step
This function inserts an empty step into the currently selected step
number. Subsequent steps will be moved one step to the right.
Rotate Step
This function rotates the step settings.
For example, suppose there is a pattern of Length 4.
If you select Forward, the settings of Step 1 will be rewritten to 2,
Step 2 →3, Step 3 →4, Step 4 → 1.
If you select Backward, the settings of Step 1 will be
rewritten to 4, Step 2 → 1, Step 3 → 2, Step 4 → 3.
Write Drum Kits
Write Drum Kits is available on the DRUMKIT pages.
This saves all drum kits 00 (INT)–47 (USER).
You must write an edited drum kit if you want to keep it. Edited
drum kits cannot be recovered if you turn off the power before
saving them.
Rename Drum Kit
Rename Drum Kits is available on the DRUMKIT pages.
This renames a drum kit.
For more information, please see “Editing names” section on
page 124 of the Operation Guide.
Initialize Drum Kit
This function initializes the currently selected drum kit. This can
be executed if user drum kit 42 (User)-57 (User) is selected.
1. Select This/All Users.
This: Initializes only the selected drum kit.
All Users: Initializes all drum kits in the User bank.
2. To execute initialization, press the OK button. To cancel
without executing, press the CANCEL button.
Copy Drum Kit
Copy Drum Kits is available on the DRUMKIT pages.
This function copies the settings of another drum kit to the
currently-edited drum kit.
Note: Drum kits 48 (GM)–56 (GM) cannot be edited, but you may
copy them to another drum kit and then edit them.
Select the copy source drum kit (From).
When you execute Copy Drum Kit, the settings of the
currently selected drum kit will be overwritten.
Copy Key Setup
Copy Key Setup is available on the DRUMKIT pages.
This function copies the settings of an individual key to another
key. You can also copy settings from two or more contiguous keys
at once.
1. In the “From Key” fields, select the range of keys that you
wish to copy.
2. In the “To Key” field, select the copy destination key.