Korg KROSS - Echo Plus

Effect Guide
270
096: Echo Plus
This models a famous analog tape echo unit. On the original
device, “echo” was created by a playback head, and the “delay
time” was specified by adjusting the speed of the motor. The
warmth and subtlety of the echoes it generated made this “lo-fi”
unit a favorite with many pro musicians.
097: Auto Reverse
This effect records the input signal and automatically plays it in
reverse (the effect is similar to a tape reverse sound).
Rec Mode
Reverse Time [ms]
When “Rec Mode” is set to Single, you can set up to 2,640 msec
for “Reverse Time.” If recording starts during the reverse
playback, the playback will be interrupted.
When “Rec Mode” is set to Multi, you can make another recording
during the reverse playback. However, the maximum Reverse
Time is limited to 1,320 msec.
If you wish to record a phrase or rhythm pattern, set “Rec Mode”
to Single. If you record only one note, set “Rec Mode” to Multi.
The “Reverse Time” parameter specifies the maximum duration of
the reverse playback. The part in excess of this limit will not be
played in reverse. If you wish to add short pieces of the reverse
playback of single notes, make the “Reverse Time” shorter.
Paramter Value Explanation
Time [ms] ← 0...539 Sets the delay time
Feedback ← 0...100
Sets the amount of
feedback
Tone ← 1...100
Sets the tone of the
delay sound
LoDamp[%]
Low Damp
[%]
0...100
Sets the damping
amount in the low
range p.266
InLvl Dmod
Input Level
Dmod [%]
–100...+100
Sets the modulation
amount of the input
level p.261
Src
Input Level
Mod Source
Off...Tempo
Selects the
modulation source
for the input level
p.261
Wet/Dry ←
Dry, 1 : 99...
99 : 1, Wet
Sets the balance
between the effect
and the dry input
Src Source Off...Tempo
Selects a modulation
source for Wet/Dry
Amt Amount –100...+100
Sets the modulation
amount for Wet/Dry
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Delay
Feedback
Low Damp
Tone
Input Level
D-mod
Paramter Value Explanation
Rec Mode ← Single, Multi
Sets the recording
mode p.271
Reverse Time
[ms]
← 20...2640
Sets the maximum
duration of the
reverse playback
p.271
Env Sel Envelope Dmod, Input
Selects whether the
start and end of
recording is
controlled via the
modulation source or
the input signal level
p.271
Src Source Off...Tempo
Selects the
modulation source
that controls
recording when
Envelope Select is set
to Dmod p.271
Threshold ← 0...100
Sets the recording
start level when
Envelope Select is set
to Input p.271
Response ← 0...100
Sets the speed of the
response to the end
of recording
Direct Mix ←
Always On,
Always Off,
Cross Fade
Selects how a dry
sound is mixed p.271
Wet/Dry ←
Dry, 1 : 99...
99 : 1, Wet
Sets the balance
between the effect
and the dry input
Src Source Off...Tempo
Selects a modulation
source for Wet/Dry
Amt Amount –100...+100
Sets the modulation
amount for Wet/Dry
Input
D-mod
Envelope Select
D
-mod
Envelope Control
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Auto Reverse
Direct
Mix
Rec/Reverse Play
Control