Combination mode
94
11–2: MFX1 (Master Effect1)
Here you can edit the parameters of the effect you selected for
MFX1 in the C–MFX> SETUP page.
Effect On/Off [Off, On]
This turns master effect 1 on/off. This is linked with the on/off
setting in the C–MFX> SETUP page.
Ch (Control Channel) [Ch01...16, G ch]
Specifies the MIDI channel that will control dynamic modulation
(Dmod) for the master effect.
Ch01…Ch16: The specified MIDI channel will be used for
control.
G ch: The global MIDI Channel (G–MIDI> BASIC) will be used
for control. Normally you will use the G ch setting.
MFX1 Parameters
Here you can set the effect parameters of the insert effect you
chose in the C–MFX>SETUP page.
For details on the master effects, please see the “Effect Guide” on
page 207.
11–3: MFX2 (Master Effect2)
These pages let you edit the parameters of Master Effect 2. To
select different effects types, use the C–MFX> SETUP page.
The parameters for MFX2 is the same as for MFX1.
For more information, please see “11–2: MFX1 (Master Effect1)”
above.
V
11–1...3: FUNCTION
•0:
Write Combination, Write/Initialize Combination
see page
94
•1: Solo Setting see page 63
•2: Compare see page 64
•3: Auto Song Setup see page 64
•4: Add to Favorite see page 94
•5: Copy from Program see page 95
•6: Copy Master Effect see page 66
For more information, please see the “Combination: FUNCTION”
section on page 94.
Combination: FUNCTION
Procedure for each function
1. Press the FUNCTION button to open the function list.
2. Adjust settings in the dialog box.
For details on the settings in each dialog box, refer to the expla-
nation of each function.
3. Press the OK button to execute, or press the Cancel button
if you decide not to execute.
Write Combination, Write/Initialize
Combination
Use these functions to save (write) an edited combination to
internal memory. You can also initialize a user bank combination.
Be sure to Write any Combination that you wish to keep. If
you turn off the power, or select another Combination before
writing an edited Combination, it cannot be recovered.
For the procedure, refer to “Write Program, Write/Initialize
Program” on page 63.
Solo Setting
This turns Solo on/off for each timbre. For more information,
please see the “Solo Setting” section on page 63.
Compare
Use this function when you want to compare the sound of the
combination you're editing with the sound prior to editing (i.e., the
saved sound). This function is the same as in Program mode.
For more information, please see the “Compare” section on
page 64.
Auto Setup Song
This function automatically copies the settings of the program or
combination to a song, and enables the record-standby status
For more information, please see the “Auto Song Setup” section
on page 64.
Add to Favorite
This function adds the program that you've selected in Program
mode (or the combination that you've selected in Combination
mode) to Favorites. This function is the same as in Program mode.
For more information, please see the “Add to Favorite” section on
page 64.
To Next Page
Loading...
