Korg KROSS - B (Arpeggiator-B)

Sequencer mode
126
•In Track Select, choose Track03.
Playing the keyboard when the ARP button is off will play the
sound assigned to track 3.
Playing the keyboard when the ARP button is on will cause
arpeggiator B to run for track 3, and play the sound assigned to
track 3.
• Alternatively, you could choose Track01 in Track Select to run
arpeggiator A for tracks 1 and 2, and use an external MIDI
device connected to the KROSS’s MIDI IN to send note data to
MIDI channel 3 to play arpeggiator B.
The arpeggiator cannot be triggered by the notes played by
the sequencer.
If the track Status (SEQ> PROG) is set to INT or BTH,
tracks 1–16 where arpeggiator A or B are assigned will be
sounded by the note data generated by the arpeggiator,
regardless of the MIDI Channel (S–TRACK> MIDI) setting
of that track. If the track Status is set to BTH, EXT, or EX2,
the track will transmit MIDI note data on the MIDI Channel
of that track.
In this case, arpeggiator A or B will be triggered by the MIDI
Channel of any track 1–16 where the corresponding
arpeggiator is assigned.
If the Local Control On (G–MIDI> BASIC) setting is turned
OFF, the arpeggiator will not be triggered by note data from
the keyboard. It will be triggered by note data received at
MIDI IN. If you wish to record just the trigger notes on an
external sequencer and run the KROSS’s arpeggiator in this
way, turn Local Control OFF.
If you want the note data generated by the arpeggiator to be
recorded on the external sequencer, turn Local Control ON,
and turn off the echo back function of the external sequencer.
(see page 320)
Track Info.
Shows the settings of tracks 1–16 for the parameter that you're
editing.
Note: If this is disabled because of the setting of another
parameter, “–” is shown
7–2: A (Arpeggiator–A),
7–3:B (Arpeggiator–B)
Pattern* [Preset: UP...Preset: RANDOM, 0000…1279]
Octave* [1, 2, 3, 4]
Resolution* [
  ,  ,   ,  ,   ,  ,   ,  ]
Gate [000...100%, Step]
Velocity [001...127, Key, Step]
Swing [–100...+100%]
Sort* [Off, On]
Latch* [Off, On]
Key Sync.* [Off, On]
Keyboard* [Off, On]
These settings are the same as for a program.
For more information, please see the “13: P–ARP (Arpeggiator)”
section on page 51.
* These parameters can also be set from “0–5: ARP
(Arpeggiator)”.
Pattern - B
Pattern - A
Pattern - A
Track2 MIDI Ch=2ch Status=INT
Arpeggiator
A
Arpeggiator
B
Arpeggiator
Assign
A
A
Pattern - A
Pattern - B
Trigger
= Ch1, Ch2
Trigger
= Ch3
Track3 MIDI Ch=3ch Status=INTB
Track1 MIDI Ch=1ch Status=INT