Sequencer mode
134
10–4: MIXER
1...5 (IFX 1...5)
Pan [L000...C064...R127]
Bus Select [Off, L/R]
Send1 [000...127]
Send2 [000...127]
FX Control Bus [Off, FC1, FC2]
These settings are the same as for a program.
See “16–4: MIXER” on page 61
10–1...4: FUNCTION
•0: Memory Status see page 137
•1: Solo Setting see page 63
•2: Undo see page 137
•3: Create New Song see page 137
•4: Rename Song see page 137
•5: Delete Song see page 137
•6: Copy From Song see page 137
•7:
Copy from Combination
see page 138
•8: Copy from Program see page 139
•9: Load Template Song see page 139
• 10: Save Template Song (Save as User Template Song) see
page 140
• 11: GM Initialize see page 141
• 12: FF/REW Speed see page 142
• 13: Set Location (Set Location for Locate Key) see page
142
• 14: Copy Insert Effect see page 151
• 15: Swap Insert Effect see page 151
• 16: DKit IFX Patch see page 151
For more information, please see the “Sequencer: FUNCTION”
section on page 137.
11: S–IFX
11–1: IFX1 (Insert Effect1)
Here you can edit the parameters of the insert effect 1, which you
selected in the S–FX ROUTING> IFX page.
Effect On/Off [Off, On]
Turns the insert effect on/off. This is linked with the On/Off setting
in the S–FX ROUTING> IFX page.
Ch (Control Channel) [Ch01...16, All-R]
This specifies the MIDI channel that will control dynamic
modulation (Dmod) for the insert effect.
Ch01...Ch16: The insert effect will be controlled on the specified
MIDI channel.
All-R: The channel of any track routed through this effect can be
used to control the effect. (Channels of each routed track will be
indicated by “*”.)
If a Track is using a Drum Kit, and the Track’s Bus Select
(S–FX ROUTING> BUS ) is DKit, this affects the MIDI
Control Channel as well. In this case, the Track’s MIDI
channel will be used to control any effect where the Ch is set
to All-R, regardless of the Bus Select (Global DRUMKIT>
VOICE) settings or the settings of the DKit IFX Patch
function.
IFX1 Parameters
Here you can set the effect parameters of the insert effect you
chose in the S–FX ROUTING> IFX page.
For more information, please see the “Insert Effects (IFX1–IFX5)”
section on page 210.
11–2: IFX2 (Insert Effect2) ,
11–3: IFX3 (Insert Effect3),
11–4: IFX4 (Insert Effect4),
11–5: IFX5 (Insert Effect5)
Here you can edit the effect parameters for insert effects 2–5
selected in the Insert FX Setup page.
For more information, please see “8–4: IFX1” above.
11–1...5: FUNCTION
•0: Memory Status see page 137
•1: Solo Setting see page 63
•2: Undo see page 137
•3: Copy Insert Effect see page 151
•4: Swap Insert Effect see page 151
•5: FF/REW Speed see page 142
•6: Set Location (Set Location for Locate Key) see page 142
Pan Bus Select FX Control Bus
To Next Page
Loading...
