Korg KROSS - IFX (Insert FX Setup)

10: S–FX ROUTING (Effect Routing) 10–3: IFX (Insert FX Setup)
133
10–3: IFX (Insert FX Setup)
Here you can choose the type of each insert effect 1 through 5, its
on/off status, chaining, and adjust the post-IFX mixer settings. For
insert effects, the direct sound (Dry) is always stereo-in and out.
The input/output configuration of the effect sound (Wet) depends
on the effect type. For descriptions of the individual effects, please
see “Effect Guide,” beginning on page 207.
The following parameters are the same as in Program mode. For
more information, please see “16–3: Insert FX Setup” on page 60.
However, unlike in Program mode, insert effect dynamic
modulation (Dmod) and the post-IFX Pan: #8, Send 1, and Send
2 are controlled on the MIDI channel specified by Ch (S–IFX>
IFX1–5). The control changes used are the same as in Program
mode.
The pan (CC#8), send 1 and 2 settings you make here will be used
when the song is played or recorded from the beginning. If you
change the settings while recording a MIDI track, the changes will
be recorded as part of the musical data, and the settings will
change when the data is played back. You can also change these
settings during playback. However if pan (CC#8), send 1, or 2 data
has been recorded, the settings will change accordingly.
If Status (SEQ> PROG) is either INT or BTH, CC#8,
CC#93, and CC#91 can be received to control the pan
following the insert effect, send 1, or send 2 respectively, and
change their settings. When you switch songs or return to the
beginning of the song, tracks whose Status is BTH, EXT, or
EX2 will transmit these settings via MIDI. This data will be
transmitted on the MIDI channels specified in the IFX 1–5
pages (S–IFX> IFX1–5). (See G–MIDI> OUT: SEQ Mode
“Track MIDI Out” on page 162)
1 (IFX1)
Effect On/Off [Off, On]
Effect Select [000, S00...S63, D00...D10]
Category/IFX Select menu:
Chain [Off, On]
Chain to [2...5]
2 (IFX2)
Effect On/Off [Off, On]
Effect Select [000, S00...S61, D00...D09]
Chain [Off, On]
Chain to [3...5]
3 (IFX3)
Effect On/Off [Off, On]
Effect Select [000, S00...S61, D00...D09]
Chain [Off, On]
Chain to [4, 5]
4 (IFX4)
Effect On/Off [Off, On]
Effect Select [000, S00...S61, D00...D09]
Chain [Off, On]
5 (IFX5)
Effect On/Off [Off, On]
Effect Select [000, S00...S61]
These settings are the same as for a program.
See “16–3: Insert FX Setup” on page 60
Eect On/O Eect Select Chain Chain to