Korg KROSS - Comp - Mt.delay (Compressor - Multitap Delay)

Single size effects 113: Early Reflections
279
115: Comp - Mt.Delay ( Compressor -
Multitap Delay)
This effect combines a mono compressor and a multitap delay.
You can change the order of the effects.
116: Limiter - Mt.Delay (Limiter -
Multitap Delay)
This effect combines a mono limiter and a multitap delay. You can
change the order of the effects.
Paramter Value Explanation
Compressor
C Sens Sensitivity 1...100
Sets the sensitivity
p.217
C Attack Attack 1...100
Sets the attack level
p.217
Level Out Level 0...100
Sets the compressor
output level p.217
C EQ Trim Pre EQ Trim 0...100
Sets the EQ input
level
C LEQ
Low EQ Gain
[dB]
–15...+15
Sets the gain of Low
EQ
C HEQ
High EQ
Gain [dB]
–15...+15
Sets the gain of High
EQ
Multitap Delay
DT1[ms]
Tap1
Time [ms]
0.0...548.0
Sets the Tap1 delay
time
Tap1 Level ← 0...100
Sets the Tap1 output
level p.267
D T2[ms]
Tap2
Time [ms]
0.0...548.0
Sets the Tap2 delay
time
Fback(T2)
Feedback
(Tap2)
–100...+100
Sets the Tap2
feedback amount
HiDamp [%]
High Damp
[%]
0...100
Sets the damping
amount in the high
range p.266
D W/D [Dly]Wet/Dry
Dry,
1 : 99...99 : 1,
Wet
Sets the multitap
delay effect balance
Src [Dly]Source Off...Tempo
Selects the Wet/Dry
modulation source
for the multitap delay
Amt [Dly]Amount –100...+100
Sets the Wet/Dry
modulation amount
for the multitap delay
Routing ←
Comp
→Delay,
Delay →
Comp
Switches the order of
the compressor and
multitap delay
Wet/Dry ←
Dry, 1 : 99...
99 : 1, Wet
Sets the balance
between the effect
and the dry input
Src Source Off...Tempo
Selects a modulation
source for Wet/Dry
Amt Amount –100...+100
Sets the modulation
amount for Wet/Dry
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Routing
Compressor
LEQ HEQ
EQ Trim
Output Level
Envelope - Control
Multitap Delay
Feedback
High Damp
Delay
(2)
(1)
Mt.Dly Wet / Dry
Comp
Paramter Value Explanation
Limiter
L Ratio Ratio
1.0 : 1...
50.0 : 1, Inf : 1
Sets the signal
compression ratio
p.218
Thrsh [dB]
Threshold
[dB]
–40...0
Sets the level above
which the
compressor is applied
p.218
L Attack Attack 1...100 Sets the attack time
Release ← 1...100 Sets the release time
L Gain [dB]
Gain Adjust
[dB]
–Inf,
–38...+24
Sets the limiter
output gain p.218
Multitap Delay
D T1[ms]
Tap1
Time [ms]
0.0...1360.0
Sets the Tap1 delay
time
Tap1 Level ← 0...100
Sets the Tap1 output
level p.267
D T2 [ms] Tap2 Time 0.0...1360.0
Sets the Tap2 delay
time
F. b ac k ( T 2 )
Feedback
(Tap2)
–100...+100
Sets the Tap2
feedback amount
HiDamp [%]
High Damp
[%]
0...100
Sets the damping
amount in the high
range p.266
D W/D [Dly]Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the multitap
delay effect balance
Src [Dly]Source Off...Tempo
Selects the multitap
delay’s Wet/Dry
modulation source
Amt [Dly]Amount –100...+100
Sets the multitap
delay’s Wet/Dry
modulation amount
Routing ←
Limiter →
Delay, Delay
→ Limiter
Switches the order of
the limiter and
multitap delay
Wet/Dry ←
Dry, 1 : 99...
99 : 1, Wet
Sets the balance
between the effect
and the dry input
Src Source Off...Tempo
Selects a modulation
source for Wet/Dry
Amt Amount –100...+100
Sets the modulation
amount for Wet/Dry
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Routing
Multitap Delay
Feedback
High Damp
Delay
(2)
(1)
Mt.Dly Wet / Dry
Limiter
Limiter
Gain Adjust
Envelope - Control