Korg KROSS - Recording Control

Audio Recorder
192
Recording control
To perform audio recorder operations such as recording, playback,
and undo, use the front panel AUDIO REC (PLAY/PAUSE)
button ( ), and also the audio recorder setup dialog box
that appears when you hold down the EXIT button ( ) and
press the AUDIO REC (PLAY/PAUSE) button ( ).
AUDIO REC (PLAY/PAUSE) button ( )
Controls recording, playback, and pause for the audio song. The
operating status is shown by the color, and the state of the LED (lit
or blinking). In each state, pressing this button will perform the
following actions.
• LED unlit = Stopped: Press the button to start playback.
• Green LED blinking = Playback paused: Press the button to
start playback.
• Green LED lit = Playing: Press the button to pause playback.
• Red LED blinking = Recording paused: Press the button to start
recording.
• Orange LED blinking = Recording paused: Start recording by
inputting the trigger specified by Auto.
• Red LED lit = Recording: Press the button to pause recording.
If you hold down the EXIT button ( ) and press the
AUDIO REC (PLAY/PAUSE) button ( ), the audio
recorder setup window appears.
Audio Recorder Setup window
In this window you can control recording, stop, pause, and
playback, as well as perform functions such as undo and create a
new audio song. Use the buttons located below the display to
control the recorder.
FUNCTION (FUNC) button
This button shows the function menu where you can use functions
such as creating a new sound, renaming, deleting, exporting, or
adjusting the level. (see page 195)
PAGE– (UNDO) button
Shows the UNDO dialog box. Here is where you can step back to
an earlier recording take. You’ll also use this button for the Redo
function which brings back a recorded take. (see page 192)
PAGE+ (Stop/Reset) button
This is the stop button. It stops playback or recording of the audio
song. When you stop, the recorder will return to the stored
location. If you press locate while stopped, you’ll return to the
beginning 0:00:00 of the song.
MENU (Rec Control) button
This is the record button. It controls record-pause and record-start.
The functionality of the button will depend on the current state. In
each state, pressing this button will perform the following actions.
= While stopped: Press the button to enter the record-pause
state.
= When shown: Press the button to start recording.
= Recording: Press the button to switch to playback.
Foot switch
You can use a foot switch to switch between play/play-pause or
record/record-pause (Foot SW Assign =Audio Recorder Start/
Pause, Audio Recorder REC Start/Stop). (see page 307)
Record
Record-
pause
Audio recorder button operation list
Play
Play-
pause
Stop
Always possible
Blinking red
Store location
Store location
To stored
location
Stored when
Play → Operation
Stored when
Stop → Operation
To 0:00:00
Lit red
Blinking green
Lit green
Foot SW=
Audio Recorder
REC Start/Stop
Foot SW=
Audio Recorder
Start/Pause
Status
(When Auto=O)
(Other than when Auto=O: Play while standing by for trigger-recording)
(Auto=other than O: blinking orange)
Foot SW=
Audio Recorder
Start/Pause
Operations available while in the setup window
Audio recorder button operation list
UndoFunc Stop/Reset Rec Control