Korg KROSS - Detune

Effect Guide
260
modulation source specified with the “Source” parameter is turned
on.
When “LFO Mode” is set to 1-Shot, the Doppler effect is created
only once when the modulation source specified in the “Source”
field is turned on. At this time if you do not set the “Source”
parameter, the Doppler effect will not be created, and no effect
sound will be output.
The effect is off when a value for the modulation source
specified for the “Source” parameter is smaller than 64, and
the effect is on when the value is 64 or higher. The Doppler
effect is triggered when the value changes from 63 or smaller
to 64 or higher.
Pitch Depth
With the Doppler effect, the pitch is raised when the sound
approaches, and the pitch is lowered when the sound goes away.
This parameter sets this pitch variation.
Pan Depth
This parameter sets the width of the stereo image of the effect
sound. With larger values, the sound seems to come and go from
much further away. With positive values, the sound moves from
left to right; with negative values, the sound moves from right to
left.
079: Detune
Using this effect, you can obtain a detune effect that offsets the
pitch of the effect sound slightly from the pitch of the input signal.
Compared to the chorus effect, a more natural sound thickness will
be created.
Input Level Dmod [%]
Source
This parameter sets the dynamic modulation of the input level.
080: Pitch Shifter
This effect changes the pitch of the input signal. You can select
from three types: Fast (quick response), Medium, and Slow
(preserves tonal quality). You can also create an effect where the
pitch is gradually raised (or dropped) using the delay with
feedback.
Paramter Value Explanation
Pitch [c]
Pitch Shift
[cents]
–100...+100
Sets the pitch
difference from the
input signal
Src Source Off...Tempo
Selects a modulation
source for pitch shift
Amt Amount –100...+100
Sets the modulation
amount for pitch shift
Delay[ms]
Delay Time
[ms]
0...1000 Sets the delay time
Feedback ← –100...+100
Sets the feedback
amount
HiDamp [%]
High Damp
[%]
0...100
Sets the damping
amount in the high
range
InLvl Dmod
[%]
Input Level
Dmod [%]
–100...+100
Sets the modulation
amount of the input
level p.261
Pitch
Higher
Doppler - Pitch / Pan Depth
Lower
Original Pitch
Left
Center
Right
Pitch Depth
Pan Depth
< < < < < <<<<<< >>>>>> > > > > >
VolumeLouder
Louder
Pan Depth
= (–) value
Pan Depth
= (+) value
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Input Level
Input Level
+
High Damp
Delay
Feedback
Detune
Src Source Off...Tempo
Selects the
modulation source
for the input level
p.261
Wet/Dry ←
Dry, 1 : 99...
99 : 1, Wet
Sets the balance
between the effect
and the dry input
Src Source Off...Tempo
Selects a modulation
source for Wet/Dry
Amt Amount –100...+100
Sets the modulation
amount for Wet/Dry
Paramter Value Explanation
Mode ← Med...Fast
Switches Pitch Shifter
mode p.261
Pitch Shift
Shift
[1/2tone]
–24...+24
Sets the pitch shift
amount by steps of a
semitone p.261
Src Source Off...Tempo
Selects the
modulation source of
pitch shift amount
p.261
Amt Amount –24...+24
Sets the modulation
amount of pitch shift
amount p.261
Fine [cents] ← –100...+100
Sets the pitch shift
amount by steps of a
cent p.261
Amt
Amount
[cents]
–100...+100
Sets the modulation
amount of pitch shift
amount p.261
Delay[ms]
Delay Time
[ms]
0...2000 Sets the delay time
Feedback
Position
← Pre, Post
Switches the
feedback connection
p.261
Feedback ← –100...+100
Sets the feedback
amount p.261
HiDamp [%]
High Damp
[%]
0...100
Sets the damping
amount in the high
range
InLvl Dmod
[%]
Input Level
Dmod [%]
–100...+100
Sets the modulation
amount of the input
level p.261
Src Source Off...Tempo
Selects the
modulation source
for the input level
p.261
Input Level
Louder
Max
Zero
Higher
D
-mod
Input Level
Max
Zero
Higher
D
-mod
x1.0
x0.5
Input Level Dmod= +100
Input Level Dmod= +50
Louder
x1.0
x0.5
Input Level Dmod= –100
Input Level Dmod= –50
Input Level Dmod
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Input Level
Input Level
+
High Damp
Delay
Feedback
Pitch Shifter
Feedback Position
Pre
Post