Sequencer mode
122
5: S– MIDI FILTER
Here you can select whether or not to apply filtering to the MIDI
data received by MIDI tracks 1–16. For example even if two tracks
are receiving the same MIDI channel, one can be set to respond to
damper pedal activity while the other does not.
These MIDI filter settings have no effect on the MIDI
messages that have already been recorded.
These settings affect the MIDI messages that are transmitted
when you adjust program, pan, volume, portamento and send
1/2 parameters of a track whose Status (SEQ> PROGc) is set
to BTH, EXT, or EX2.
On (checked): Reception of MIDI data is enabled. Tracks where
the Status (SEQ> PROG) is INT or BTH will receive these types
of MIDI messages on their respective channels. The type of effects
that are checked will be applied to the program of each track when
the KROSS’s controllers are used or when MIDI data is received.
(The effect dynamic modulation function is not affected by these
settings.)
Settings that regulate MIDI transmission/reception of the KROSS
itself are created in the MIDI Filter (G–MIDI> FILTER).
If the user-assignable controllers that can be filtered in the MIDI
Filter 3 pages are set to MIDI control changes, filtering will be
performed for these control changes. In this case, any control
change filtering that is being performed in the MIDI Filter 1 to 2
pages will be given priority. Furthermore, if the same control
change is assigned to multiple controllers where there are filter
settings in the MIDI Filter 4 pages, checking any one of these will
enable that control change.
Off (unchecked): Reception of MIDI data is disabled.
Note: MIDI CC# = MIDI control change message numbers.
Track 01...16 (Track Number)
To select a track, place the cursor at one of the following
parameters, and use the cursor buttons to switch tracks. (see
page 105)
Track Info.
Shows the settings of tracks 1–16 for the parameter that you're
editing.
Note: If this is disabled because of the setting of another
parameter, “–” is shown.
5–1: 1 (MIDI Filter1)
Enable Program Change [Off, On]
Specifies whether or not MIDI program change messages will be
received.
Enable After Touch [Off, On]
Specifies whether or not MIDI after touch messages will be
received.
Enable Damper [Off, On]
Specifies whether or not MIDI CC#64 hold (damper pedal)
messages will be received.
Enable Portamento SW [Off, On]
Specifies whether or not MIDI CC#65 portamento on/off
messages will be received.
5–2: 2 (MIDI Filter2)
Enable Pitch Bend as AMS [Off, On]
Specifies whether or not MIDI pitch bend messages (usage of the
pitch bend wheel) will be received to control the AMS effect
assigned to Pitch Bend. (This is not a filter for MIDI pitch bend
message reception.) For more information, please see the
“Alternate Modulation Sources (AMS)” section on page 291.
Enable Mod. Wheel CC#01 [Off, On]
Specifies whether or not MIDI CC#1 (the usage of the modulation
wheel) will be received.
Enable JS–Y CC#02 [Off, On]
Specifies whether or not MIDI CC#2 will be received.
Enable Ribbon CC#16 [Off, On]
Specifies whether or not MIDI CC#16 will be transmitted or
received.
To Next Page
Loading...
Need help?
General
