Korg KROSS - Delay

Sequencer mode
120
Note: You can also set the note values and velocity values by
keyboard (see page 13 of the Operation Guide).
4–3: DELAY
This specifies the time (delay) from when the MIDI tracks 1–16
receive a note-on message until the sound begins.
Track 01...16 (Track Number)
To select a track, place the cursor at one of the following
parameters, and use the cursor buttons   to switch tracks. (see
page 105)
Delay Time [ms] [0000…5000ms, KeyOff]
Specifies the time (delay time) from note-on until the MIDI track
begins to produce sound, in units of ms (1/1000th of a second).
This setting is available if MIDI/Tempo Sync. is set to Off.
KeyOff: The note will begin sounding at note-off. In this case, the
sound will not die away if the sustain level of the program’s amp
EG is other than 0. This setting is used when creating harpsichord
sounds.
Normally you will set this to 0000.
MIDI/Tempo Sync. [Off, On]
The time (delay time) from note-on until the track produces sound
will be specified in note length units relative to the  (Te mpo).
On (checked): Specify the delay time in terms of a Base Note and
Times relative to the Tempo . For example if Base Note = , Times
= 01, and Tempo = 60 BPM, the delay time will be equivalent to
1000 ms.
Off (unchecked): The delay time will be set by the Delay Time
setting.
Base Note [ ,   ,  ,   ,  ,   ,  ,   ,  ,  ]
Times [01...32]
It specifies the time (delay time) from note-on until the track
begins to produce sound, in terms of a note value relative to the 
(Tempo) (SEQ> MAIN).
Use Base Note to specify the desired note value, and use Times to
extend that note value by the specified multiple.
For example if you set Base Note to a quarter note (  ) and Times
to 02, that track will sound with a delay of a half note (  ). Even if
you change  (Tempo), the delay time will always be a half note
(  ). If you use these parameters to specify a delay of a half note
(  ). In this case, a Tempo of 60.00 BPM will produce a 2000 ms
delay, and a Tempo of 120.00 BPM will produce a 1000 ms delay.
Track Info.
Shows the settings of tracks 1–16 for the parameter that you're
editing.
If this is disabled because of the setting of another parameter, “–”
is shown.
Bottom Velocity Top Velocity
Velocity
Volume
Bottom Slope
Top Slope
How volume will change according to keyboard location