Korg KROSS - Global, Media: FUNCTION

Global/Media mode
176
Dev. Type: The type of device.
Product ID: (Not shown on the KROSS)
Format Type: The type of format. If not formatted, this will
indicate “Unformatted.”
Total Si ze: The capacity of the media (in bytes).
Free Size: The free capacity of the media (in bytes).
Write Protect: The write protect status of the media. This will
indicate “On” if protected, or “Off” if not protected.
Removable: Removable disk.
V 6–1, 2: FUNCTION
6–1
•0: Load Preload/Demo Data see page 176 (only FILE page)
•1: Save All (PCG & SEQ) see page 184 (only FILE page)
•2: Save PCG see page 184 (only FILE page)
•3: Save SEQ see page 185 (only FILE page)
•4: Save to Standard MIDI File see page 185 (only FILE
page)
6–2
•0: Rename see page 185 (only UTILITY page)
•1: Delete see page 186 (only UTILITY page)
•2: Format see page 186 (only UTILITY page)
•3: Set Date/Time see page 186 (only UTILITY page)
For more information, please see the “Global, Media:
FUNCTION” section on page 176.
6–3
0: Rename see page 185 (only UTILITY page)
Global, Media: FUNCTION
Procedure for each function
1. Press the FUNCTION button to open the function list.
2. Adjust settings in the dialog box.
For details on the settings in each dialog box, refer to the
explanation of each function.
3. Press the OK button to execute, or press the Cancel button
if you decide not to execute.
Write Global Setting
Write Global Setting is available on all of the tabs under the
GLOBAL G–MIDI, G–INPUT/CTRL, and G–USERSCALE
pages.
This function writes Global mode settings (except for Drum Kits
and Arpeggio Patterns).
The following are exceptions.
Parameters that are not saved even if you Write
• Effect SW(see page 157)
Load Preload/Demo Data
Load Preload/DemoData is available on the GLOBAL pages.
This function loads the preloaded data and demo song data into the
KROSS.
Before you can load this data, you must navigate to Memory
Protect (GLOBAL> SYSTEM) and un-check the protect
setting for the type of data you want to load. If you perform
this function with the protect setting checked, the display will
indicate “Memory Protected,” and the data will not be
loaded.
When you perform this function, the data of the preload
banks will be rewritten. If you want to keep the data of the
preload banks, use “Save All” and “Save PCG” to save it
before you continue.
1. Use Kind to select the type of data you want to load.
Kind Content
All (Preload PCG and
Demo Songs)
All PCG (Program, Combination, Global settings,
drum kit, , arpeggio pattern), and demo song
data
All Preload PCG All PCG data
All Demo Songs All demo song data
Program Program data
Combination Combination data
Drum Kit Drum kit data
Arpeggio Pattern Arpeggio pattern data
Global Setting Global setting data, Favorites data