2: S–LOOP/TONE 2–3: EG ADJ (EG Adjust)
115
Track 01...16 (Track Number)
To select a track, place the cursor at one of the following
parameters, and use the cursor buttons to switch tracks. (see
page 105)
Cutoff (Filter Cutoff) [–99...+99]
Adjusts the cutoff frequency of filters A and B.
Resonance (Filter Resonance) [–99...+99]
Adjusts the resonance of filters A and B.
EG Intensity (Filter EG Intensity) [–99...+99]
Adjusts the effect of the filter EG on the cutoff frequency of filters
A and B.
Vel. Intensity (Amp Velocity Intensity) [–99...+99]
Adjusts the velocity intensity for the amp level.
Track Info.
Shows the settings of tracks 1–16 for the parameter that you're
editing.
Note: If this is disabled because of the setting of another
parameter, “–” is shown.
2–3: EG ADJ (EG Adjust)
Track 01...16 (Track Number)
To select a track, place the cursor at one of the following
parameters, and use the cursor buttons to switch tracks. (see
page 105)
Attack (Filter/Amp EG Attack Time) [–99...+99]
This scales the attack times of the Filter and Amp EGs, along with
other related parameters.
When the value is +1 or more, this also affects the Amp EG’s Start
and Attack Levels, Start Level AMS, and Attack Time AMS.
Between values of +1 and +25, the Start Level, Start Level AMS,
and Attack Time AMS will change from their programmed values
to 0. Over the same range, the Attack Level will change from its
programmed value to 99.
Decay (Filter/Amp EG Decay Time) [–99...+99]
This scales the decay and slope times of the Filter and Amp EGs.
Sustain (Filter/Amp EG Sustain Level) [–99...+99]
This scales the sustain levels of the Filter and Amp EGs.
Release (Filter/Amp EG Release Time) [–99...+99]
This scales the release times of the Filter and Amp EGs.
Track Info.
Shows the settings of tracks 1–16 for the parameter that you're
editing.
Note: If this is disabled because of the setting of another
parameter, “–” is shown.
2–1...3: FUNCTION
•0: Memory Status see page 137
•1: Solo Setting see page 63
•2: Undo see page 137
•3: Create New Song see page 137
•4: Rename Song see page 137
•5: Delete Song see page 137
•6: Copy From Song see page 137
•7:
Copy from Combination
see page 138
•8: Copy from Program see page 139
•9: Load Template Song see page 139
•10: Save Template Song (Save as User Template Song) see
page 140
•11: GM Initialize see page 141
•12: FF/REW Speed see page 142
•13: Set Location (Set Location for Locate Key) see page
142
For more information, please see the “Sequencer: FUNCTION”
section on page 137.
To Next Page
Loading...
Need help?
General
