Sequencer: FUNCTION Assign inst to Tone
151
Assign inst to Tone
Assign inst to Tone is available on the S–STEP SEQ pages.
Here's how to assign an instrument to each tone of the step
sequencer. This function is the same as in Program mode.
For more information, please see the “Assign inst to Tone” section
on page 65.
Edits Step Parameters
Edit Step Seq is available on the S–STEP SEQ pages.
Here you can specify velocity and accent on/off for each step. This
function is the same as in Program mode.
For more information, please see the “Edits Step Parameters”
section on page 65.
Copy Step Seq
Copy Step Seq is available on the S–STEP SEQ pages.
This function copies the step sequencer settings from the program,
combination, or song that you specify. This function is the same as
in Program mode.
For more information, please see the “Copy Step Seq” section on
page 65.
Copy Insert Effect
Copy Insert Effect is available on all of the S–FX ROUTING and
S–IFX pages.
For more information, please see the “Copy Insert Effect” section
on page 66.
However, the MIDI control channel specified in Ctrl Ch of the
IFX 1–5 page will not be copied.
Swap Insert Effect
Swap Insert Effect is available on all of the S–FX ROUTING and
S–IFX pages.
For more information, please see the “Swap Insert Effect” section
on page 66.
However, the MIDI control channel specified in Ctrl Ch of the
IFX 1–5 page will not be swapped.
DKit IFX Patch
This patches the Bus Select settings for each key of a drum kit,
temporarily changing the insert effect connection destinations.
You can execute this function if the program assigned to the track
is a drum program and Bus Select is set to DKit.
For more information, please see the “DKit IFX Patch” section on
page 96.
Copy Master Effect
Copy MFX is available on all of the S–MFX pages.
For more information, please see the “Copy Master Effect” section
on page 66.
However, the MIDI control channel specified in Ctrl Ch of the S–
MFX> MFX 1, MFX2 page will not be copied.
To Next Page
Loading...
Need help?
General
