Program mode
66
On (checked): The parameter settings of the STEP SEQ>
BASIC–MIX pages will be copied.
Off (unchecked): The parameter settings of the STEP SEQ>
BASIC–MOD pages will be copied (except for Program).
The on/off state of “Program Settings too” will affect only the
settings of the MIX page.
If you're using this function in Combination or Sequencer mode,
the settings of the STEP SEQ> MIX page parameters will be
copied. However, the MIDI Channel setting will not be copied.
If you choose this function when the STEP SEQ on/off setting is
Off, the STEP SEQ on/off setting will be forced On, and the
various settings will be copied.
If you've chosen Combination or Song in the From field, the
Program will not be copied if the copy-source STEP SEQ on/
off setting is Off.
Copy Insert Effect
Copy Insert Effect is available on the P–FX ROUTING and P–
IFX pages.
This function copies effects settings from within the current
Program, from other Programs, Combinations, or Songs.
To execute the Copy Insert Effect function, press the OK button.
To cancel, press the Cancel button.
If you’re copying from a master effect, the result will not be
identical due to differences in the routing and level settings of
the master effects.
From (Mode) [Program, Combination, Song]
This selects whether you’ll copy from a Program, a Combination,
or a Song.
From (Category and Number) [Category and Number]
For Programs and Combinations, this selects the Category and
Number from which to copy.
(Effects slot select) [IFX 1…5, MFX 1&2]
Select which of the effects you wish to copy.
You can also copy from a master effect.
All [check-box]
When this is enabled, the settings of all insert effects (the contents
of the Insert FX page and the effect parameters of IFX1–5, but not
Ctrl Ch) will be copied.
To [IFX 1…5]
This selects the insert effect copy destination.
Post IFX Mixer Setting [check-box]
When this is checked, the Pan, Bus Select, FX Control Bus, and
Sends 1 and 2 settings that follow the copy source insert effect will
also be copied.
When this is not checked, only the effect type and its parameters
will be copied.
Swap Insert Effect
Swap Insert Effect is available on the P–FX ROUTING and P–
IFX pages.
This function exchanges the effects, and their internal parameters,
between two IFX slots.
All of the parameters shown on the IFX 1–5 pages will be copied.
Other IFX slot parameters will not be affected, including Pan,
Sends 1 and 2, Chain, and FX Control Bus.
1. In Source 1 and Source 2, select each of the insert effects
that you wish to swap.
Copy Master Effect
Copy Master Effect is available on the P–MFX pages.
This function lets you copy any desired effect settings from
Program, Combination, or Song.
1. Use the From field to select the copy source mode, category,
and number.
2. Select the effect that you want to copy.
You can copy from an insert effect by selecting IFX1–5.
If you copy from an insert effect, the result may not be exactly
the same, due to differences in routing and level settings.
If you select MFX1 or MFX2, the Return level will be copied
at the same time.
If you check All, all master effect settings will be copied.
3. In To, specify the copy destination master effects.
To Next Page
Loading...
