Global, Media: FUNCTION Copy Scale
179
If you’re transmitting data from a computer, connect the KROSS’s
USB connector to your computer’s USB connector.
If you’re transmitting data from another KROSS or from a MIDI
data filer, connect the target KROSS’s MIDI IN connector to the
MIDI OUT connector of the transmitting device.
2. Set the MIDI channel of the transmitting device to match
the KROSS’s global MIDI channel MIDI Channel (G–
MIDI> BASIC).
If you want the KROSS to receive data that was previously
transmitted to a MIDI device, you must set the global MIDI
channel of the KROSS to the same global MIDI channel that was
used when the data was transmitted.
To set the MIDI channel of the transmitting device, please see the
owner’s manual for that device.
3. In the G-MIDI> FILTER page, select the Enable Exclusive
check box.
When one of these functions is displayed, data dumps can be
received regardless of the Enable Exclusive setting.
4. Transmit the data from the other device. For the proce-
dure, please see the owner’s manual for the device you are
using.
Copy Scale
Copy Scale is available on the Scales page.
This function copies data from a preset scale to a user scale or
copies a user scale to another user scale location. For details on the
preset scales, please see “Scale Type” on page 10.
1. Use the From field to select the copy-source scale.
If you select Pure Major or Pure Minor, specify the Key (located at
the right) as well.
Stretch cannot be selected if To is User All Notes Scale.
2. In To, selects the copy destination scale.
Write Arpeggio Patterns
Write Arpeggio Patterns is available on the APR PATTERN
pages.
This function writes user arpeggio patterns 0000–1027.
Pattern, (Tempo), Octave, Resolution, Sort, Latch, Sync
(Key Sync), and Kbd (Keyboard) are parameters that are set
in Program, Combination, and Song. The Write operation
executed here does not save these parameters.
If you move here from Program or Combination mode and
set these parameters, you must return to the original mode
and write them.
Rename Arpeggio Pattern
Rename Arpeggio Pattern is available on the ARPEGGIATOR
pages.
This function renames the selected user arpeggio pattern.
Preset patterns UP–RANDOM cannot be renamed.
For more information, please see “Editing names” section on
page 124 of the Operation Guide.
Copy Arpeggio Pattern
Copy Arpeggio Pattern is available on the ARPEGGIATOR
pages.
This function copies the settings of another user arpeggio pattern
to the currently selected arpeggio pattern.
It is not possible to copy from a preset arpeggio pattern UP–
RANDOM.
Select the copy source arpeggio pattern From.
Be aware that when you execute Copy Arpeggio Pattern, all
settings of the currently selected arpeggio pattern will be
overwritten.
Initialize Arpeggio Pattern
This function initializes the currently selected arpeggio pattern.
This can be executed if user arpeggio pattern 1024 or later is
selected.
1. Select This/All Users.
This: Initializes only the selected arpeggio pattern.
All Users: Initializes all arpeggio patterns 1024 and later.
2. To execute initialization, press the OK button. To cancel
without executing, press the CANCEL button.
Initialize Steps
This function initializes the step parameters (Tone , Pitch Offset,
Gate, Velocity, Flam) of the arpeggio pattern.
Type:Empty will initialize all tones to a blank state.
Type: Full will initialize all tones to a full state.
Copy Step
This function copies the settings of a specific step. The settings of
two or more adjacent steps can also be copied together.
To Next Page
Loading...
