Global/Media mode
178
Dump:
Dump Program
Dump Combination
Dump Favorite
Dump Drum Kit
Dump Arpeggio Pattern
Dump Global Setting
Dump Sequence
Dump All
These functions are available on the MIDI page.
These functions allow the internal data from the KROSS to be
transmitted to another KROSS, MIDI data filer, or computer in the
form of MIDI System Exclusive data.
Select the desired function (please see the following table), and a
dialog box will appear.
Then, select the bank or timbre etc. of the data to be dumped, and
press the OK button.
Sending SysEx data dumps
Do not touch the KROSS’s buttons or turn off the power
while SysEx data is being transmitted.
Sending a data dump
1. Connect the KROSS to the device that will receive the data
dump.
If you want to transmit the data to a computer that is able to
receive SysEx messages, connect the KROSS’s USB connector to
your computer’s USB connector.
If you want to transmit the data to another KROSS or to a MIDI
data filer, connect the KROSS’s MIDI OUT connector to the MIDI
IN connector of the receiving device.
2. Select GLOBAL G–MIDI page.
3. The following illustration shows the dialog box that will
appear when Dump Program is selected.
If you want to dump one bank, select Bank, or if you want to
dump one program select Single.
4. Use the To field to select the output connector that will
transmit the data.
MIDI: MIDI OUT connector
USB: USB connector
5. Press the OK button to transmit the data.
While the data is being transmitted, the display will indicate “Now
Transmitting MIDI data.”
The size of the data and the time required for transmission will
depend on the type of data.
The following table shows the size of each data dump, and the
time required (MIDI).
*1:The USB-MIDI dump times listed here are for when the
KROSS is connected to a computer with a USB 1.1 port. The
time required will change depending on the computer system
you're using.
Note: More time will be required if the song data contains System
Exclusive events, since these must be converted.
When performing a data dump from the KROSS onto a MIDI
data filer, do not transmit multiple data dumps together. If
multiple data dumps are saved together, and the KROSS later
attempts to receive this data, it will not have enough
processing time to write the data into memory, making it
impossible for all of the data to be received.
Receiving SysEx data dumps
Do not touch the KROSS’s switches or turn off the power
while SysEx data is being received.
Before receiving data, close any dialog box, PAGE menu, or
function.
After a data dump is received, the KROSS will require
approximately one second to process the data and write it into
memory. During this time, the display will show the message,
“Now writing into internal memory.” While this message is
shown, under no circumstances should you turn off the power
of the KROSS. If the power is turned off during this time, the
KROSS may fail to operate correctly when the power is
turned on again. In this case, hold down the EXIT button
together with PAGE button, and turn on the power. However,
this will initialize the contents of memory.
Transmission and reception of any other MIDI data is also
impossible during this time. When receiving multiple data
dumps in succession, you must allow enough time between
each data dump for the message to disappear from the screen.
MIDI cannot be transmitted or received while data is being
written into internal memory. Also, transmission of Active
Sensing (FEh) from the MIDI OUT connector and USB
connector will be halted.
Receiving a data dump
1. Connect the KROSS with the device that will transmit the
data dump.
Dump Program
Programs of all banks, programs of one bank,
one program
Dump Combination
Combinations of all banks, combinations of one
bank, one combination
Dump Favorite
Favorites of all banks, favorites of one bank, one
favorite
Dump Drum Kit All drum kits, one drum kit
Dump Arpeggio
Pattern
All arpeggio patterns, one arpeggio pattern
Dump Global setting
Global settings (except for the Drum Kits and
Arpeggio Patterns of Global mode)
Dump Sequencer All song data
Dump All All of the above data
Type of data to be
dumped
Data size
(Bytes)
Time
required
MIDI (Sec.)
Time
required
USB-MIDI
(Sec.)
*1
Program All 3130750 1001.84 7.83
Program Bank 313075 100.18 0.78
Program Single 2469 0.79 0.01
Combination All 2027683 648.86 5.07
Combination Bank 289669 92.69 0.72
Combination Single 2286 0.73 0.01
Favorite All 2345 0.75 0.01
Favorite Bank 316 0.10 0.01
Favorite Single 42 0.01 0.01
Drum Kit All 578565 185.14 1.45
Drum Kit Single 9998 3.20 0.02
Arpeggio Pattern All 807521 258.41 20.2
Arpeggio Pattern Single 654 0.21 0.01
Global Setting 5714 1.83 0.01
Sequencer
21927...
1961194
7.02...
627.58
0.05...4.90
To Next Page
Loading...
