Korg KROSS - Page 43

8: P–Amp 8–3: KEYTRK (Keyboard Track)
35
High-Top [–Inf, –99...+99, +Inf]
This sets the slope between the Key High key and the top of the
MIDI note range. For normal key track, use positive values.
+Inf and –Inf ramps
+Inf and –Inf are special settings which create abrupt changes for
split-like effects. When a ramp is set to +Inf or
–Inf, the keyboard tracking will go to its extreme highest or lowest
value over the span of a single key.
When a ramp is set to +Inf, the keyboard tracking will go to its
highest value (double the programmed volume) over a single half-
step.
Similarly, when a ramp is set to –Inf, the keyboard tracking will go
to its lowest value (complete silence) over a single half-step.
Note: If you set the Cent Hi (Center-High) ramp to +Inf or
–Inf, the Hi Top (High-Top) parameter will be grayed out.
Similarly, if you set the Lo Cent (Low-Center) ramp to +Inf or –
Inf, the Btm Lo (Bottom-Low) ramp will be grayed out.
Amp KTrk is also an AMS source
You can use the keyboard tracking as an AMS source to modulate
other parameters, just like the envelopes and LFOs. Simply select
Amp KTrk in the AMS list for the desired parameter.
V 8–1...3: FUNCTION
•0: Write Program, Write/Initialize Program see page 63
•1: Solo Setting see page 63
•2: Compare see page 64
•3: Auto Song Setup see page 64
•4: Add to Favorite see page 64
•5: Copy Oscillator see page 64
•6: Swap Oscillator see page 64
For more information, please see the “Program: Function” section
on page 63.
Ramp Change in level
–Inf Silent in one half-step
–99 Silent in one whole-step
–95 Silent in one octave
–48 Silent in two octaves
–25 Silent in four octaves
00 no change
+25 x2 in four octaves
+50 x2 in two octaves
+99 x2 in one octave
+Inf x2 in one half-step