5: C–MIDI FILTER 5–3: 3 (MIDI Filter3)
83
5–3: 3 (MIDI Filter3)
Timbre 01...16 (Timbre Number)
To select a timbre (active timbre), place the cursor at one of the
following parameters, and use the cursor buttons to switch
timbres.(see page 71)
Enable SW1 [Off, On]
Enable SW2 [Off, On]
These settings specify whether SW1 Mod (CC#80) and SW2 Mod
(CC#81) will be transmitted and received if they are assigned to
the SW1 and SW2 buttons.
Note: If Portamento SW (CC#65) is assigned to SW1 or SW2, the
Enable Portamento SW setting on the 1 (MIDI Filter1) page will
take priority.
Note: The functions of SW1 and SW2 are assigned on the C–
INPUT/CTRL> CONTROLLERS page (see page 74).
Enable Foot Pedal [Off, On]
If a control change is assigned to the ASSIGNABLE PEDAL, this
specifies whether the effect will be transmitted and received. The
function is assigned in the GLOBAL G-INPUT/CTRL> FOOT
page.
Enable Foot Switch [Off, On]
If a control change is assigned to the ASSIGNABLE SWITCH,
this specifies whether the effect will be transmitted and received.
The function is assigned in the GLOBAL G-INPUT/CTRL>
FOOT page.
Timbre Info.
Shows the settings of timbres 1–16 for the parameter that you're
editing.
Soloed timbres are indicated by (S).
5–4: 4 (MIDI Filter4)
Timbre 01...16 (Timbre Number)
To select a timbre (active timbre), place the cursor at one of the
following parameters, and use the cursor buttons to switch
timbres.(see page 71)
Enable Other CC Messages [Off, On]
Specifies whether or not MIDI control messages not covered in the
preceding items MIDI Filter will be transmitted and received.
Timbre Info.
Shows the settings of timbres 1–16 for the parameter that you're
editing.
Soloed timbres are indicated by (S).
Note: If this is disabled because of the setting of another
parameter, “–” is shown.
V
5–1...4: FUNCTION
•0:
Write Combination, Write/Initialize Combination
see page
94
•1: Solo Setting see page 63
•2: Compare see page 64
•3: Auto Song Setup see page 64
•4: Add to Favorite see page 94
•5: Copy from Program see page 95
For more information, please see the “Combination: FUNCTION”
section on page 94.