KRONE ISOBUS Terminal
164
Pos: 48.152 /BA/Inf o-Center/CCI-I SOBUS-Terminal/CCI- Press-Wickelvorric htung/Hauptmenüs/ Hauptmenü 4 Service/B3 P osition Netz Motor einste llen (vorerst nur X-tr eme) @ 214\mod_13908074356 07_78.docx @ 1759769 @ @ 1
B3 Adjusting position of net engine:
Retracting/extending the motor and saving positions
CC000290
Fig. 123
Caution!
The feed and cut-off positions must be approached and stored.
Note
They can only be saved if the bar is in the lower or upper rectangle of the bar display.
Moving the engine out
• Softkey moves the engine out as long as the softkey is pressed or until the feed
position is reached (see Menu 3-1 "Manual operation baler").
Storing a value:
• Press function button until the symbol appears briefly in the upper line.
Note
The value is stored when the right bar has accepted the value of the centre bar.
Pos: 48.153 /Layout Mod ule /---------- -----Seitenumbruc h------------- --- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1
To Next Page
Loading...
