Krone Comprima CF 155 XC - Page 167

KRONE ISOBUS Terminal
167
Pos: 48.156 /BA/Inf o-Center/CCI-I SOBUS-Terminal/CCI- Press-Wickelvorric htung/Hauptmenüs/ Hauptmenü 4 Service/Sensor B9/B10 Ballendur chmesser einstellen _ C omprima CV150 XC @ 53\mod_1289986 321953_78.doc x @ 507676 @ @ 1
Adjust sensor B9/B10 bale diameter (Comprima CV150XC):
CC000291
4
X
VPN00012_4
6
III
COM00011_1
5
4
6
7
Fig. 125
Before you readjust or correct the setting of the sensor (7) “B9/B10 bale diameter,” make certain
the stop (6) for the soft core setting is in Pos. III (soft inner bale core). A setting may only be
made on the sensor (7) only in this position.
Soft core setting:
• Open the bale chamber.
• Remove the screw (5).
• Move stop (6) to Pos. III (soft inner bale core).
• Install and tighten the screw (5).
• Close the bale chamber.