Operation
237
Pos: 55.101 /Abkürzu ngen /Abkürzungen sprac hneutral/Rundbal lenpressen/Compri ma CV 150 XC (fett) @ 83\mod_1317 819279881_78.doc x @ 731653 @ @ 1
Comprima CV 150 XC
Pos: 55.102 /BA/Bedienu ng /Rundballenpresse/ Bild Splint-Bo lzen @ 59\mod_1297668505 549_78.docx @ 558766 @ @ 1
CPK00221_1
1
2
CPK00225_2
3
Fig. 177
Pos: 55.103 /BA/Bedienu ng /Rundballenpresse/ Nach längerer Standzei t @ 59\mod_129766799 7846_78.docx @ 558739 @ @ 1
After an extended standstill time prior to placing the machine into service again (only if the
baling pressure has dropped below 50 bar):
• To uncouple, remove the cotter pin and bolt (1) for the slip-on gear (2)
• Use a lever (3) to pull out the slip-on gear (2) and disconnect with the bolt
• Switch on tractor PTO
• Open tailgate once and close again to build up minimum pressure
• Then set the desired baling pressure as described above
• Switch off tractor PTO
• Insert the slip-on gear (2) again and secure with bolt and cotter pin (1)
Pos: 55.104 /BA/Bedienu ng /Rundballenpresse/ Hinweis Druckber eich @ 59\mod_12976690 41046_78.docx @ 558793 @ @ 1
Note
A pressure range of 50-180 bar is preset for the baling pressure setting.
Pos: 55.105 /BA/Bedienu ng /Rundballenpresse/ Tabelle Druc kbereich @ 59\mod_12976691344 67_78.docx @ 558820 @ @ 1
Crop Pressure range (bar)
Hay low
Straw medium/high
Silage high
Pos: 55.106 /Layout Mod ule /---------- -----Seitenumbruc h------------- --- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
