Operation
238
Pos: 55.107 /Abkürzu ngen /Abkürzungen sprac hneutral/Rundbal lenpressen/Compri ma CV 210 XC @ 140\mod_1355302382 014_0.docx @ 1248291 @ @ 1
Comprima CV 210 XC
Pos: 55.108 /BA/Bedienu ng /Rundballenpresse/ Bild Splint-Bo lzen HD @ 100\mod_1330339276 927_78.docx @ 891541 @ @ 1
HDC00022
1
2
a
b
Fig. 178
Pos: 55.109 /BA/Bedienu ng /Rundballenpresse/ Nach längerer Standzei t HD @ 101\mod_133095 4348579_78.docx @ 900481 @ @ 1
After an extended standstill time prior to start-up of the machine (only if the baling pressure has
dropped below 50 bar):
Pos: 55.110 /BA/Bedienu ng /Rundballenpresse/ Teil 2: Aufsteckge triebe umsetzen (Nur für X-treme Maschinen) @ 227\ mod_1392795870876_78. docx @ 1829841 @ @ 1
HDC00087
5
Fig. 179
• Hook hand lever (4) into the bore hole (5) and hook (6) into the oblong hole of the slip-on
gear (2). The hand lever can be readjusted in the oblong hole (7) of the hook (6), if
necessary.
• Push the slip-on gear (2) into position (a) by using hand lever (4) and secure with cotter pin
(1).
• Remove auxiliary device and put it down in the twine box.
Pos: 55.111 /BA/Bedienu ng /Rundballenpresse/ Hinweis Druckber eich @ 59\mod_12976690 41046_78.docx @ 558793 @ @ 1
Note
A pressure range of 50-180 bar is preset for the baling pressure setting.
Pos: 55.112 /BA/Bedienu ng /Rundballenpresse/ Tabelle Druc kbereich @ 59\mod_12976691344 67_78.docx @ 558820 @ @ 1
Crop Pressure range (bar)
Hay low
Straw medium/high
Silage high
Pos: 55.113 /Layout Mod ule /---------- -----Seitenumbruc h------------- --- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
