MSA SUPREMA - Page 5

REV 0, June 2005 Page 5
Operation Manual SUPREMA
5.10.5 Reset Terminal (Reset Latching Alarms) ............................................................ 154
5.10.6 Acknowledge Terminal (Reset Horn Relay)......................................................... 154
5.10.7 LOCR Terminal ................................................................................................... 154
5.10.8 Password Terminal ............................................................................................. 154
5.11 Connection for the System Power Supply .......................................................... 154
5.11.1 Calculation of the Required Power Supply .......................................................... 154
5.11.2 Connection of the DC-Voltage Supply (MIB Module) ........................................... 156
5.11.3 Connection of the Internal Rack Power Supply Unit (MSP Module) .................... 157
5.12 Labelling Concept................................................................................................ 158
5.12.1 Plug-In modules .................................................................................................. 158
5.12.2 Slots in the Rack ................................................................................................. 159
5.12.3 Connection and Terminal Modules on the Rack .................................................. 159
5.12.4 Connection and Terminal Modules in Rail-Mounted Installation........................... 160
5.12.5 MAT(-TS) Connector Plug ................................................................................... 160
6. Startup................................................................................................................ 161
6.1 Turn On the Supply Voltage ................................................................................. 161
6.2 System Configuration .......................................................................................... 162
6.2.1 Configuration Tool................................................................................................ 162
6.3 Start the Sensors ................................................................................................ 168
6.3.1 Presetting of Passive Sensors ............................................................................ 168
6.3.2 Auxiliary Equipment Required ............................................................................. 168
6.3.3 MAI Module - Instrument Status “A” and “B” ........................................................ 169
6.3.3.1 Adjust the Sensor Current ................................................................................... 169
6.3.3.2 Preadjust the Zero Point/Sensitivity..................................................................... 170
6.3.4 MAI Module – from Instrument Status “C”............................................................ 172
6.3.4.1 Setting the Sensor Current.................................................................................. 172
6.3.4.2 Presetting of Zero/Sensitivity ............................................................................... 173
6.3.5 Preadjust the Active Sensors (MAI Module)......................................................... 175
6.3.6 Configure the Sensors ........................................................................................ 175
6.3.6.1 Set the System Parameters................................................................................ 176
6.3.6.2 Set the Input Parameters .................................................................................... 177
6.3.6.2.1 Information Menu ................................................................................................. 177
6.3.6.2.2
Sensor Data Menu .............................................................................................. 177
6.3.6.2.3 Alarms Menu........................................................................................................ 178
6.4 Configure the Relay Driver Outputs (Switching Outputs) ................................... 179
6.4.1 Configure the Relay Driver Outputs .................................................................... 179
6.4.2 Behaviour of the Relay Outputs........................................................................... 181
6.5 Preliminary Calibration ........................................................................................ 183
6.5.1 Passive Sensors ................................................................................................. 183
6.5.2 Presetting of Passive Sensors ............................................................................ 183
6.5.3 Active Sensors .................................................................................................... 185
6.6 Completing Startup.............................................................................................. 186
7. Maintenance and Service ................................................................................ 187
7.1 Maintenance and Adjustment .............................................................................. 187
7.1.1 Passive Sensors ................................................................................................. 187
7.1.2 Active Sensors .................................................................................................... 189
7.1.3 Separate Zero Adjustment ................................................................................... 193
7.2 Sensor Simulation Modules................................................................................. 194
7.2.1 Description of Function of Sensor Simulation Module 4-20mA, WT, HL ............. 194
7.3 Replacement of Sensors .................................................................................... 195
7.4 Replacement of Modules..................................................................................... 195