11A-26
TOP AND FRONT OF ENGINE
Timing belt: Removal - Refitting
K4M
11A
a Position the RENAULT badge (27) etched on the
stem of each camshaft sprocket vertically and point-
ing upwards.
2 - Refitting
a Refit a new timing tensioning roller by positioning the
lug of the timing tensioning roller in the groove (28) .
a Screw on the timing tensioning roller nut without
tightening it.
a Refit a new timing belt starting with the sprocket of
each camshaft (without moving the sprocket of each
camshaft).
a Fit the tool (29) on the camshaft sprockets (use the
bolt and nut of the upper timing cover to fit the tool).
14487-3
108879
135896
Note:
Take care to properly tighten the timing belt
between the two camshaft sprockets.
Note:
If the engine is equipped with a crankshaft timing
sprocket with a collet, take care to properly
tighten the timing belt between the exhaust cam-
shaft sprocket and the crankshaft timing
sprocket.
To Next Page
Loading...
