10A-3
ENGINE AND CYLINDER BLOCK ASSEMBLY
Crankshaft seal on timing end: Removal - Refitting
K9K
10A
a Screw the threaded rod (10) of theinto the crank-
shaft.
a On the crankshaft, fit the spacer (11) of the.
a Fit the protector with the new seal in place on the
spacer, taking care not to touch the seal.
a Fit the cover (12) and nut (13) (with the thread (14)
of the nut towards the outside of the engine) of the.
20772
20771
20770
20769
To Next Page
Loading...
