10A-7
ENGINE AND CYLINDER BLOCK ASSEMBLY
Crankshaft seal, gearbox end: Removal - Refitting
K4M or K9K
10A
a Mount theon the crankshaft, securing it using bolts
(10) .
a Fit the protector with its seal in place on the, taking
care not to touch the seal.
a Fit the cover (11) and nut (12) (with the thread (13)
of the nut towards the outside of the engine) of the.
a Tighten the nut until the cover touches the cylinder
block.
20760
20761
20762
20763
To Next Page
Loading...
