Renault Duster 2007 - Page 330

19A-29
COOLING
Engine cooling fan assembly: Removal - Refitting
K4M
19A
a Unclip the « condenser - expansion valve » connect-
ing pipe at (9) .
a Pull the fan assembly according to the arrows (10)
passing it under the « condenser - expansion
valve » connecting pipe.
a
a Remove the engine cooling fan assembly from
above the vehicle.
In the event of replacement
a Remove from the fan assembly:
-the power-assisted steering hose clips,
-the wiring clip.
REFITTING
I - REFITTING PREPARATION OPERATION
In the event of replacement
a Refit on the fan assembly:
-the power-assisted steering hose clips,
-the wiring clip.
II - REFITTING OPERATION
a Proceed in the reverse order to removal.
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
III - CHECKING THE OPERATION OF THE FAN UNIT
a Start the engine.
a Disconnect the coolant temperature sensor connec-
tor.
a Check the operation of the fan assembly.
a Connect the coolant temperature sensor connector.
a Switch off the engine.
144817
WARNING
In order to avoid any refrigerant leaks, do not
damage (deform, twist, etc.) the pipe.
Note:
Do not damage the cooling unit vanes (radiator,
condenser, etc.) during handling.