Renault Duster 2007 - Page 680

52A-6
NON-SIDE OPENING ELEMENT MECHANISMS
Bonnet release cable: Removal - Refitting
52A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove:
-the front bumper (see 55A, Exterior protection,
Front bumper: Removal - Refitting, page 55A-8)
,
-the bonnet catch (see 52A, Non-side opening el-
ement mechanisms, Bonnet lock: Removal -
Refitting, page 52A-5) ,
-the bonnet release catch (see 52A, Non-side
opening element mechanisms, Bonnet release
control: Removal - Refitting, page 52A-4) .
II - REMOVAL OPERATION
a Note the route of the bonnet release cable.
a Unclip the bonnet opening cable at (1) .
a Remove the remote headlight beam adjustment
control cables (see Remote headlight beam ad-
justment control: Removal - Refitting) (84A, Con-
trol - Signals).
a Remove the blanking piece cable (2) .
a Remove the bonnet release cable from inside the
vehicle.
REFITTING
a Proceed in the reverse order to removal.
a Carry out a function test.
108718
108637