10A-58
ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine - gearbox assembly: Removal - Refitting
K4M
10A
a Remove the power-assisted steering low pressure
pipe bolt (22) on the front axle subframe.
a Remove:
-the power-assisted steering high pressure pipe bolt
(23) on the gearbox,
-the power-assisted steering high pressure pipe bolt
(24) on the gearbox support,
-the earth strap bolt (25) on the gearbox.
a Remove (see Compressor: Removal - Refitting)
(62A, Air conditioning):
- the pipe retaining bracket bolt on the compressor,
- the pipe union bolts on the compressor.
a Disconnect the compressor pipes.
a Fit blanking plugs in the pipe openings.
a Disconnect the air conditioning pressostat connec-
tor.
a Move aside the cooling hose clips (26) on the cool-
ant pump inlet pipe using the (Mot. 1448).
a Disconnect:
- the cooling hoses on the coolant pump inlet pipe,
- the vacuum pipe on the inlet distributor chamber.
24762
145559
AIR CONDITIONING
Note:
Plugs must be fitted on the hoses to prevent
moisture from entering the system.
116559
To Next Page
Loading...
