82A-4
ENGINE IMMOBILISER
Ignition switch: Removal - Refitting
82A
a Check that the ignition key is in position (5) .
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
-the switch,
-the switch bolt.
a Clip:
-the connector to the switch,
-the connector for the switch on its mounting.
III - FINAL OPERATION.
a Refit the transponder ring (see 82A, Engine immo-
biliser, Transponder ring: Removal - Refitting,
page 82A-5) .
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-2) .
To Next Page
Loading...
