85A-4
WIPING - WASHING
Windscreen wiper arm: Removal - Refitting
85A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Switch on the ignition.
a Turn the wiper stalk from (0) to (1), and then from (1)
to (0).
a Switch off the ignition.
a Mark the position of the wiper arms (3) .
a Fold back the nut covers (4) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the windscreen wiper arm nuts (8) .
a Remove the wiper arms using the.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Switch on the ignition.
a Turn the wiper stalk from (0) to (1), and then from (1)
to (0).
a Switch off the ignition.
a Refit:
- the wiper arms in the position marked before re-
moval,
- the wiper arm nuts.
a Torque tighten the wiper arm nuts (16 N.m).
II - FINAL OPERATION
a Fit the nut covers.
Tightening torquesm
wiper arm nuts 16 N.m
WARNING
To ensure that the wiper arms can travel
smoothly, the wiper motor must be initialised.
140941
140942
WARNING
To ensure that the wiper arms can travel
smoothly, the wiper motor must be initialised.