Schweitzer Engineering Laboratories SEL-421-4 - Page 1234

14.28
SEL-400 Series Relays Instruction Manual Date Code 20171006
ASCII Command Reference
Command Description
GOOSE
Use the GOOSE command to display transmit and receive GOOSE messaging
information, which can be used for troubleshooting.
The information displayed for each GOOSE IED is described in Table 14.71.
Ta b l e 1 4.70 G O O S E C o m m and
Command Description Access Level
GOOSE Displays GOOSE information 1, B, P, A, O, 2
GOOSE k Displays GOOSE information successively for k times 1, B, P, A, O, 2
Table 14.71 Accessible GOOSE IED Information (Sheet 1 of 2)
IED Description
Transmit GOOSE
Control Reference
This field represents the GOOSE control reference information that
includes the IED name, ldInst (Logical Device Instance), LN0 lnClass
(Logical Node Class), and GSEControl name (GSE Control Block
Name) (e.g., SEL_411L_OtterCFG/LLN0$DSet13).
Receive GOOSE
Control Reference
This field shall contain the goCbRef (GOOSE Control Block Refer-
ence) information that includes the iedName (IED name), ldInst (Logi-
cal Device Instance), LN0 lnClass (Logical Node Class) and cbName
(GSE Control Block Name) (e.g., SEL_411L_1CFG/LLN0$DSet13)
Multicast Address
(MultiCastAddr)
This hexadecimal field represents the GOOSE multicast address.
Priority Tag (Ptag) This three-bit decimal field represents the priority tag value, where
spaces are used if the priority tag is unknown.
VLAN (Vlan) This 12-bit decimal field represents the virtual LAN (Local Area Net-
work) setting, where spaces are used if the virtual LAN is unknown.
State Number
(StNum)
This hexadecimal field represents the state number that increments with
each state change.
Sequence Number
(SqNum)
This hexadecimal field represents the sequence number that increments
with each GOOSE message sent.
Time to Live (TTL) This field contains the time (in ms) before the next message is
expected.
Code This text field indicates warning or error conditions that are abbreviated
as follows:
Code Abbreviation Explanation
OUT OF SEQUENC Out of sequence error
CONF REV MISMA Configuration Revision mismatch
NEED COMMISSIO Needs Commissioning
TEST MODE Test Mode
MSG CORRUPTED Message Corrupted
TTL EXPIRED Time to live expired
HOST DISABLED Optional code for when the host is disabled
or becomes unresponsive after the GOOSE
command has been issued