8. Groove (roughing)
1. Press the "Turning", "Groove" and "Groove with inclines" softkeys.
The "Groove 1" entry field opens.
2. Enter the following technology parameters:
T Grooving
tool
D1 F 0.150 mm/rev V 220 m/min
3. Enter the following parameters:
Machining Roughing (∇)
Groove position
Reference point
X0 60 abs
Z0 -70
B2 8 inc
T1 4 inc
α1 15 degrees
α2 15 degrees
FS1 1
R2 1
R3 1
FS4 1
D 2 inc
UX 0.4 inc
UZ 0.2 inc
N 1
Creating a ShopTurn program
9.19 Example: Standard machining
Turning
334 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
