Spectracom SecureSync User Manual

If no value is entered in the IPv4 and/or IPv6 field, SecureSync uses the system
default address.
SNMP Community names should be between 4 and 32 characters in length.
Permissions may be Read Only or Read/Write.
The Version field provides a choice of V1 or V2c.
5.
Click Submit. The created communities will appear in the SNMP V1/V2 panel:
Editing and Deleting Communities
To edit or delete a community you have created:
1.
Navigate to MANAGEMENT > NETWORK: SNMP Setup.
2.
Click the row of the SNMP V1/V2 panel that displays the community you wish to edit or
delete. The cursor will change from an arrow icon to a pointing finger to indicate that
the entry is clickable.
3.
The SNMP V1/V2c Settings for Access window will display.
Note: The options available for editing in the SNMP V1/V2c Settings for
Access window will vary contextually according to the information in the
entry chosen.
4.
To edit the settings, enter the new details you want to edit and click Submit. OR: To delete
the entry, click Delete.
2.13 Configuring Network Settings
CHAPTER 2 • SecureSync User Reference Guide Rev. 26
89

Spectracom SecureSync Specifications

General

Model	SecureSync
Time Reference	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Disciplines	GNSS, IRIG, PTP, NTP, SyncE
Inputs	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Outputs	NTP, PTP, 1PPS, IRIG
Protocols	PTP, NTP, SNMP, SSH, HTTPS
Form Factor	1U Rack-mount
Redundancy	Optional redundant power supply
Security Features	Password protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply	100-240 VAC, 50-60 Hz
Operating Temperature	0°C to +50°C
Dimensions	44.45 mm (H) x 482.6 mm (W)