Turn on the unit with NO cable plugged into the Ethernet port yet (Note: once you apply
power, it may take up to two minutes for the system to fully boot).
Configure your PC‘s network interface card (NIC) with an IP address on the same network as
the NetClock 9489‘s default IP address (10.10.201.1 ). For example, configure the IP
address of your PC‘s network interface card as 10.10.201.10 , with a subnet mask of
255.255.255.0.
Connect an Ethernet cable from your PC to the Ethernet port of the NetClock unit. Once con-
nected via crossover cable, open a web browser and enter the NetClock‘s default IP address
(10.10.201.1) into the browser‘s address bar and login to the NetClock‘s WebUI as an
administrator. Once logged in, network settings for the NetClock can be configured under
MANAGEMENT > Network Setup > Actions: General Settings and under Ports: GEAR button.
2.11.2.2 Setting Up an IP Address via the Front Panel
Assigning an IP address to SecureSync, using the front panel keypad and information display
is a preferred way to provide network access to the unit, thus enabling you thereafter to com-
plete the setup process via the WebUI.
Keypad Operation
The functions of the six keys are:
< > arrow keys: Navigate to a menu option (will be highlighted)
˄ ˅ arrow keys: Scroll through parameter values in edit displays
ENTER key: Select a menu option, or load a parameter when editing
BACK key: Return to previous display or abort an edit process
An illustration showing how to navigate the front panel menu tree can be found here: "Front
Panel Keypad, and Display" on page4
IP configuration, step-by-step instructions:
A.
Disable DHCP:
1.
Press the key.
2.
Using the arrow key, select Netv4 from the menu.
(To select a menu item, highlight it using the arrow keys, then press the key.)
48
CHAPTER 2 • SecureSync User Reference Guide Rev. 26
2.11 Setting up an IP Address
To Next Page
Loading...
Need help?
General
