Spectracom SecureSync User Manual

For each event choose the notification you want and an email address – if any – to
which you want the notification to be sent. For more information, see "SNMP" on
page84 and "Setting Up Email Notifications" on page245.
For each event, only the notification options available can be configured. For example,
a mask alarm can be set for an In-Sync event, and a Not-in-Sync event, but not for an In-
Holdover event.
4.2.2 Notification Event Types
The following types of events can be used to trigger notifications:
4.2.2.1 Timing Tab: Events
In Sync
Not In Sync
In Holdover
No Longer in Holdover
Frequency Error
Frequency Error Cleared
1PPS Not In Specification
1PPS Restored to Specification
Oscillator Alarm
Oscillator Alarm Cleared
Reference Change (Cleared)
Reference Change
4.2.2.2 GPS Tab: Events
Too Few GPS Sat, Minor Alarm
Too Few GPS Sat, Minor, Cleared
Too Few GPS Sat, Major Alarm
Too Few GPS Sat, Major, Cleared
GPS Antenna Problem
GPS Antenna OK
GPS Receiver Fault
GPS Receiver Fault Cleared
242
CHAPTER 4 • SecureSync User Reference Guide Rev. 26
4.2 Notifications

Spectracom SecureSync Specifications

General

Model	SecureSync
Time Reference	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Disciplines	GNSS, IRIG, PTP, NTP, SyncE
Inputs	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Outputs	NTP, PTP, 1PPS, IRIG
Protocols	PTP, NTP, SNMP, SSH, HTTPS
Form Factor	1U Rack-mount
Redundancy	Optional redundant power supply
Security Features	Password protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply	100-240 VAC, 50-60 Hz
Operating Temperature	0°C to +50°C
Dimensions	44.45 mm (H) x 482.6 mm (W)