Spectracom SecureSync User Manual

4.
Click Submit.
Resetting Reference Priorities to Factory Defaults
To reset all references in the Reference Priority table to their factory default priorities:
1.
Navigate to the Configure Reference Priorities screen via MANAGEMENT > OTHER: Refer-
ence Priority menu.
2.
In the Actions panel, click the Restore Factory Defaults button.
3.3.1.2 The "Local System" Reference
The Local System reference is a "Self" reference, i.e. SecureSync uses itself as an input ref-
erence for Time, or as a 1PPS reference. The Local System is a unique input reference in that it
can be used as either the Time reference, or the 1PPS reference, but never both.
Note: For SecureSync to operate as a Local System reference, you must have
either a valid external Time reference, or a valid external 1PPS reference.
When the Time reference is configured as Local System, SecureSync's System Time is con-
sidered a valid reference, as long as the external 1PPS input reference is valid.
166
CHAPTER 3 • SecureSync User Reference Guide Rev. 26
3.3 Managing References

Spectracom SecureSync Specifications

General

Model	SecureSync
Time Reference	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Disciplines	GNSS, IRIG, PTP, NTP, SyncE
Inputs	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Outputs	NTP, PTP, 1PPS, IRIG
Protocols	PTP, NTP, SNMP, SSH, HTTPS
Form Factor	1U Rack-mount
Redundancy	Optional redundant power supply
Security Features	Password protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply	100-240 VAC, 50-60 Hz
Operating Temperature	0°C to +50°C
Dimensions	44.45 mm (H) x 482.6 mm (W)