3.6.3 Configuring a TimeKeeper PTP Master
TimeKeeper is configured in the SecureSync Web UI, under MANAGEMENT > PTP Setup.
When setting up a PTP Master via TimeKeeper, the configured SecureSync interface (e.g.,
ETH0), detectable to the PTP network via its IP address, will send out synchronization packets
under the PTP protocol.
You can setup several PTP Masters, e.g. for different interfaces (if so equipped), or to serve dif-
ferent domains, or one for each PTP Version.
The following three procedures explain how to configure a PTP Master:
Procedure a): ADDING a PTP Master
Procedure b): EDITING a PTP Master
Procedure c): DELETING a PTP Master
a): ADDING a PTP Master
To add and configure a new PTP Master:
1.
Navigate to the PTP Setupscreen via MANAGEMENT > NETWORK > PTP Setup.
2.
In the PTP Masters panel, click the PLUS icon in the top right corner.
3.
The Add PTP Master pop-up window displays. Fill in the applicable parameter values:
224
CHAPTER 3 • SecureSync User Reference Guide Rev. 26
3.6 Managing TimeKeeper
To Next Page
Loading...
