3.
A notification window will confirm the status change.
4.
In the NTP Services panel, set the ON/OFF toggle switch to ON again.
Changes made will now take effect and NTP operation will be restored shortly after this oper-
ation is performed.
2.14.4 Viewing NTP Clients
To view the NTP clients being served by SecureSync:
1.
Navigate to MANAGEMENT> NETWORK: NTP Setup.
2.
In the NTP Actions panel, click View NTP Clients:
3.
The NTP Clients window will display, showing a table of the clients that are syn-
chronizing to SecureSync via NTP:
2.14 Configuring NTP
CHAPTER 2 • SecureSync User Reference Guide Rev. 26
99
To Next Page
Loading...
