Name: Spectracom SecureSync
Brand: Spectracom
Rating: 5 (1 reviews)

To Next Page

To Previous Page

2.14.8.1 The NTP Servers and NTP Peers Panels

The NTP Servers and NTP Peers panels display which servers in the network are set up at higher

or equal Stratums (Servers or Peers, respectively), and their configurations. These panels are

also used to add, configure, or remove NTP Servers and Peers.

Note: For information on how to view NTP Clients, see "Viewing NTP Clients" on

page99.

The NTP Servers and NTP Peers panels are part of the NTP Setup screen (see "The NTP Setup

Screen" on page95), which can be accessed via MANAGEMENT > NETWORK: NTP Setup.

Information provided in the NTP Servers and NTP Peers panels

The following columns are used to break down the status information for recognized NTP Serv-

ers and NTP Peers.

Note: Servers will be displayed in the Status view only if they can be resolved.

They will, however, always be displayed in the Setup view in order to recon-

figure them, if necessary.

IP/HOST: Name and real-time status (color-coded)

REF ID: Identifies the type of Input REFerence e.g., GPS indicates the reference can use

GPS for its synchronization. Below is a list of potential REF IDs reported by the

SecureSync Timing System (otherNTP Servers and Peers may report different ref-

erences):

GPS: GNSS reference

IRIG: IRIG reference

HVQ: HAVE QUICK reference

FREQ: Frequency reference

PPS: External 1PPS reference

PTP: PTP reference

106

CHAPTER 2 • SecureSync User Reference Guide Rev. 26

2.14 Configuring NTP

Questions and Answers:

Need help?

Do you have a question about the Spectracom SecureSync and is the answer not in the manual?

Spectracom SecureSync Specifications

General

Model	SecureSync
Time Reference	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Disciplines	GNSS, IRIG, PTP, NTP, SyncE
Inputs	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Outputs	NTP, PTP, 1PPS, IRIG
Protocols	PTP, NTP, SNMP, SSH, HTTPS
Form Factor	1U Rack-mount
Redundancy	Optional redundant power supply
Security Features	Password protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply	100-240 VAC, 50-60 Hz
Operating Temperature	0°C to +50°C
Dimensions	44.45 mm (H) x 482.6 mm (W)