2.4.3 SAFETY: User Responsibilities
The equipment must only be used in technically perfect condition. Check components for
damage prior to installation. Also check for loose or scorched cables on other nearby
equipment.
Make sure you possess the professional skills, and have received the training necessary
for the type of work you are about to perform.
Do not modify the equipment.
Use only spare parts authorized by Spectracom.
Always follow the instructions set out in this User Reference Guide, or in other Spec-
tracom documentation for this product.
Observe generally applicable legal and other local mandatory regulations.
2.4.4 SAFETY: Other Tips
Keep these instructions at hand, near the place of use.
Keep your workplace tidy.
Apply technical common sense: If you suspect that it is unsafe to use the product, do the
following:
Disconnect the supply voltage from the unit.
Clearly mark the equipment to prevent its further operation.
2.5 Mounting the Unit
SecureSync units can be operated on a desktop or in a rack in a horizontal, right-side-up pos-
ition. The location needs to be well-ventilated, clean and accessible.
2.5.1 Rack Mounting
If installing the unit in a rack, install the rack-mount ears on the two sides of the front panel and
mount the unit in a standard 19-inch rack cabinet. The unit is intended to be installed in one ori-
entation only. The unit should be mounted so the front panel interface keys are to the left of the
display area.
The SecureSync unit will install into any EIA standard 19-inch rack. SecureSync occupies one
rack unit of space for installation, however, it is recommended to leave empty space of at least
one rack unit above and below the SecureSync unit to allow for best ventilation.
36
CHAPTER 2 • SecureSync User Reference Guide Rev. 26
2.5 Mounting the Unit
To Next Page
Loading...
Need help?
General
