Spectracom SecureSync User Manual

Note: Whether or not notifications are enabled/disabled for a given event, the
occurrence of the event is always logged.
All available SecureSync events that can generate a notification to be sent are located under
different tabs in the Notification Events panel: Timing, GPS, and System.
The SecureSync Events that can automatically trigger a notification are listed in the Event
column. It is possible to:
Mask the alarm generation for specific events (prevent the alarm)
Enable “SNMP” (to send out an SNMP trap)
Send an email to the address specified in the corresponding “Email Address” column.
4.2.1 Configuring Notifications
To configure Notifications:
1.
Navigate to MANAGEMENT > OTHER: Notifications. The Notifications screen will display:
It is divided into two panels:
The Actions panel, featuring:
The SNMP Setup button: See "SNMP" on page84.
The Email Setup button: Configure SecureSync's interface settings for
Exchange email servers and Gmail.
For more information on this subject, see the Spectracom Technical Note
Email Notification Setup.
The Events panel, offering three tabs:
Timing: Events for Sync Status and Holdover, Frequency error, Input ref-
erences and the internal oscillator.
240
CHAPTER 4 • SecureSync User Reference Guide Rev. 26
4.2 Notifications

Spectracom SecureSync Specifications

General

Model	SecureSync
Time Reference	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Disciplines	GNSS, IRIG, PTP, NTP, SyncE
Inputs	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Outputs	NTP, PTP, 1PPS, IRIG
Protocols	PTP, NTP, SNMP, SSH, HTTPS
Form Factor	1U Rack-mount
Redundancy	Optional redundant power supply
Security Features	Password protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply	100-240 VAC, 50-60 Hz
Operating Temperature	0°C to +50°C
Dimensions	44.45 mm (H) x 482.6 mm (W)