Spectracom SecureSync User Manual

Click the Delete button next to an existing rule, if you want to delete it.
2.13.6 HTTPS
HTTPS stands for HyperText Transfer Protocol over SSL (Secure Socket Layer). This TCP/IP pro-
tocol is used to transfer and display data securely by adding an encryption layer to protect the
integrity and privacy of data traffic. Certificates issued by trusted authorities are used for
sender/recipient authentication.
Note: In order to configure HTTPS, you need ADMINISTRATORrights.
Note that SecureSync supports two different modes of HTTPS operation: The Standard HTTPS
Level (default), and a High-Security Level. For more information, see "HTTPS Security Levels" on
page266.
2.13.6.1 Accessing the HTTPS Setup Window
1.
Navigate to MANAGEMENT > NETWORK: HTTPS Setup (or, navigate to MANAGEMENT >
Network Setup, and click HTTPS in the Actions panel on the left):
2.13 Configuring Network Settings
CHAPTER 2 • SecureSync User Reference Guide Rev. 26
65

Spectracom SecureSync Specifications

General

Model	SecureSync
Time Reference	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Disciplines	GNSS, IRIG, PTP, NTP, SyncE
Inputs	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Outputs	NTP, PTP, 1PPS, IRIG
Protocols	PTP, NTP, SNMP, SSH, HTTPS
Form Factor	1U Rack-mount
Redundancy	Optional redundant power supply
Security Features	Password protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply	100-240 VAC, 50-60 Hz
Operating Temperature	0°C to +50°C
Dimensions	44.45 mm (H) x 482.6 mm (W)