SecureSync, and “y.y.y.y” is the full subnet mask for the network (For a list of
subnet mask values, see "Subnet Mask Values" on the facing page.)
5.
Configure the gateway by typing gw4set 0 z.z.z.z<Enter>
(where 0 indicates which interface routing table to add the default gateway for, and
“z.z.z.z” is the default gateway address).
Note: If your SecureSync is configured with an Ethernet option card, use 0,
1, 2, 3 for eth0 – eth3.
6.
Remove the serial cable, connect SecureSync to the network, and access the Web UI,
using the newly configured IP address. (For assistance, see "Accessing the WebUI" on
the facing page)
The remainder of the configuration settings will be performed via the Web UI (accessed via an
external workstation with a web browser such as Firefox
®
or Chrome
®
).
2.11.2.5 Setting up a Static IP Address via Ethernet Cable
This procedure will allow you to configure SecureSync using the WebUI directly via the Eth-
ernet port, if for some reason you prefer not to (or cannot) use a DHCP network.
1.
First, disable DHCP using the front panel keypad and information display:
a.
Press the ü key.
b.
Using the arrow key, select Netv4 from the menu.
(To select a menu item, highlight it using the arrow keys, then press the ü key.)
c.
Select the Ethernet interface for which DHCP is to be disabled, such as eth0.
d.
Select DHCP from the next menu. The display will show State=Enabled and
Action=Disabled.
(The State is the current DHCP setting and the Action is the action to take. You can
only change the Action setting.)
e.
Press the ü key once to select the action, then again to apply it.
2.
The front panel will now display the default static IP address 10.10.201.1/16.
3.
Change the workstation IP address to be on the same network as SecureSync.
4.
Connect workstation and SecureSync with an Ethernet cable.
Note: You may use an Ethernet crossover cable, but you do not have to.
The remainder of the configuration settings will be performed via the Web UI (accessed via an
external workstation with a web browser such as Firefox
®
or Chrome
®
). For more information,
see "The Web UI HOME Screen" on page18.
52
CHAPTER 2 • SecureSync User Reference Guide Rev. 26
2.11 Setting up an IP Address
To Next Page
Loading...
Need help?
General
