Spectracom SecureSync - Rebooting the System

2.
The Reboot/Halt window will display. Select the Shutdown the Unit checkbox.
3.
Click Submit.
4.
Wait 30 seconds after entering the HALT command before switching off the unit .
Once the HALT process has been initiated, the front panel LCD will display Power
offSecureSync, and the front panel LED time display will stop incrementing.
Issuing a HALT Command via Keypad/SerialPort/Telnet/SSH:
The HALT command can be initiated not only via the SecureSync WebUI, but also via the
keypad and LCD display. For more information on the keypad, see "Front Panel Keypad, and
Display" on page4.
With a serial connection to the front panel serial port, telnet connection or SSH connection,
type halt <Enter> to halt the unit for shutdown. For more information on SecureSync com-
mands, see "CLICommands" on page513.
Once the HALT process has been initiated, the front panel LCD will display Power off
SecureSync, and the front panel LED time display will stop incrementing.
Note: After issuing the HALT command wait 30 seconds before you remove
power.
4.1.4 Rebooting the System
To reboot SecureSync via the Web UI:
1.
Navigate to TOOLS > SYSTEM: Reboot/Halt.
238
CHAPTER 4 • SecureSync User Reference Guide Rev. 26
4.1 Powering Up/Shutting Down